n18lld

Update Turns put the brake issue was a faulty caliper. Engine running issue was a faulty aftermarket Parrot kit back feeding the steering column. Add in a faulty ignition switch and safe to say I’m skint for a while. It’s been an expensive introduction to Audi ownership.

Fault reappeared yesterday without actually using the parking brake. Got home to find I also couldn’t turn off the engine now! Key out, ignition off but engine still running and air con also. Had to pull the fuse for the engine management system to stop the engine running but air con still blowing. Now parked up with the battery disconnected. Not a happy lad.

Not deserted this thread guys. Just busy at work. Plugged in the control module again and parking break working again as it should. Tried it a dozen times and working ok.....for now I’m sure. Fault code read was Control Module for Elect Park Hand Brake (J540) - sporadic. 008 - implausible Signal

I found somewhere online that there’s a control module in the boot for this under the tool kit. Stuck my hand in and gave an angry tug so the brake released. I was in Manchester at the time and keen to get home to Glasgow. I will try and get the toolbox out and reconnect the control unit on Saturday when I can get som daylight. I’ve a Foxwell VAG tool also so will go through all your checks and report back then. Thanks for your speedy reply.

Just returned to the car to find the parking brake holding firm. Can hear the brake motors running when pushing/pulling the button but brake stuck on and malfunction warning on the dash. This is the third occasion this has happened in my 2 weeks of ownership. Once I left it overnight and all was ok and the other I kept trying until it released via the switch after an hour. This time I’m not so lucky. Any advice please.

Fancy fitting a chrome number plate holder when I put my personal plate on my new toy. Front bumper is curved so I’m thinking I will need a plinth or something of the sort. Hunted on line but can’t see anything suitable. I’m taking it the chrome holders won’t take to bending? Anyone on here found a solution? Thanks in advance. First post outside the introduction section.

New member here saying hi. Just purchased a 2004 A6 and will be scouring the forum for tips and advice. Hopefully there won’t be too much heartache with my ownership.