Jump to content

Audi A3, immobiliser / transmission issues


marvinb
 Share

Recommended Posts

marvinb     1

Hi all, im in the process of repairing a 56 plate S line A3 2.0 tdi auto.. 

In its accident some wires were severed NSF corner, which i have repaired and am 100 confident of their continuity. Before refitting all of front end with rad pack etc i though i had better make sure engine starts, it won't.. 

There is no power being sent to starter solenoid.. Instruments and fuel pump etc all seem to work ok. 

Ross tec diagnostic program just says no communication to transmission and start up prevented by immobiliser. No comms with ecu or tcu, similar readings on snap on solus too. 

Both pairs of can wires from that corner have  continuity back to gateway, ( i swapped gateway, just in case.

Car has, been off road for about 5 years, now wondering if there is an immobiliser or synchronisation issue. 

Any help will be greatly appreciated. 

Link to comment
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share




×
×
  • Create New...

Forums


News


Membership