-
Posts
4 -
Joined
-
Last visited
Content Type
Profiles
Gallery
Forums
Events
Articles
Videos
News & Articles
Premium Membership
Store
Posts posted by krashot
-
-
Hey! I am receiving on Delphi and VCDS this Code.
Is this the Relay located in the ECU Box? The J271? -
On 6/10/2020 at 8:43 AM, Steve Q said:
I'd replace the parts it advises have failed I've also read that a failing the most can cause the lambda sensor fault. And wiring issues can cause these faults. We're checking.
Cheers
Steve
Im just curious for the "Low Signal" on knock sensor 1, maybe something up with the wiring? As I switched sensor 2 with sensor 1 and error still appeared on Knock sensor 1
Thanks Steve for your prompt reply -
Hey guys! I need help for my Audi TT 1.8T 110kw AUM
On diagnostic delphi i am getting the following fault codes;
16519 - o2 sensor17511 - Lambda sensor
16711 - Low Signal Knock Sensor block 1
So when I remove those errors, the car is going perfectly but after 5 mins, errors show up.
I've tried to switch the Knock sensor 1 with knock sensor 2 but still getting error on block 1?
I've checked the N75 and replaced, still sameI have also replaced the spark plugs, timing belt, water pump, oil etc..
Any advice?
Thank you
AUDI TT MK1 1.8T 150 AUM - Wiring Issues
in Audi TT Club
Posted
Hey guys,
I have an AUDI TT MK1 1.8T 150hp AUM engine.
My car previously had AJQ engine 180hp(before I bought it). They swapped it for AUM engine. So the thing is;
Engine is AUM with AUM ECU 06A 906 032 DR BOSCH ME 7.5, but I think the Wiring harness is left for AJQ since there are no Relays(100,428 - no box either), and no Wideband o2 Sensor.
It pops PCM Relay Error fault code and S1B1 o2.
I was wondering if I replace the Big Plug Harness from AUM, will everything be okay as it should and no problems detected?
I want to add the Wideband o2 and the relays. The relays are somehow now bypassed? Car runs, no issues at all beside that it doesnt run as it should since its without an o2. Theres no hole for it too. So I have to weld and stuff.....So after explaining my issue can you tell me what would be the best option for me?
1. Replacing the complete loom + adding the relays + the o2.
2. Replacing the Big plug harness + adding the o2 + relays.
3. Buying this kit from unitronics? https://www.getunitronic.com/parts/accessories/uni-wideband-conversion-harnessAnd what's the process for this?
4. To wire the o2 from ecu? Mechanics and electricians arent really at their best here in Macedonia so I am so afraid for the last option lol.
THANK YOU!!