-
Posts
8 -
Joined
-
Last visited
Content Type
Profiles
Gallery
Forums
Events
Articles
Videos
News & Articles
Premium Membership
Store
Posts posted by ADWalker
-
-
Finally got this sorted!
The D5S bulb-holder has a little release lever, pictures to follow.
-
-
Quote14 hours ago, Stevey Y said:
Hi you offer up the bulb to the holder with the writing on the back of the bulb casing so you can read it then tilt the bulb casing about thirty degrees to the left then with light pressure toward the light unit twist the bulb in...
Thank you very much for that info, I will try that when I get a chance.
-
-
-
-
Hi Folks, I have a 2016 (facelift) 8V Fastback and one Xenon bulb is failing (occasionally flickers and has a reduced output & greenish tinge to light). I got a replacement D5S bulb and gained access to the rear of the light assembly be removing the wheelarch liner, there don't appear to be any retaining clips for the bulb (I eventually got the old one out by pulling hard and wiggling but I can't seem to get the new one seated properly (it just doesn't seem to be going all the way in), is there any 'trick' to this or any advice on how to fit the D5S bulb (these are NOT the same as the older D3S by the way - different mounting). I have made sure that there are no wires trapped between the bulb and the mounting.
Has anyone actually swapped one of these bulbs?
8V Facelift, replacing D5S Xenon bulb
in Audi A3 (8V) Forum
Posted
Pushing this lever upwards opens the three clips marked, pushing it down moves them back inwards to lock the bulb in place.
This is left-hand side (passenger) side, I haven't looked at drivers side since it involves wrestling the wheelarch liner out.