curlykevs

22 hours ago, Bigdave1230 said:

Is it a genuine cable you are using to program. If you do vcds options test what does it say. 

yes genuine cable vcds now getting channel 4 invalid so now cant set 5 

24 minutes ago, curlykevs said:

still getting no response from controller after getting all 4 valid but tried 20 times at least no response from controller 

got all 4 channels valid and tested and saved channel 5 tested and save but every time it says no response from controller so will only on automatic all others greyed out 

5 hours ago, curlykevs said:

hi it is right hand drive it is higher on passenger side 123 set ok 4 wont take it is at 410 i have tried taking it up 20mm says invalid so tried 15 still same tried 10 still same mmi is on automatic only no other settings changed front bag it is now better but cant set untill i get channel 4 sorted

still getting no response from controller after getting all 4 valid but tried 20 times at least no response from controller 

49 minutes ago, Bigdave1230 said:

Is it Left Hand Drive? Is just one corner down or both on that side. What is the value you are trying to enter? Is the mmi greyed out on the suspension settings? What parts have you changed on the car to get to this stage? 

hi it is right hand drive it is higher on passenger side 123 set ok 4 wont take it is at 410 i have tried taking it up 20mm says invalid so tried 15 still same tried 10 still same mmi is on automatic only no other settings changed front bag it is now better but cant set untill i get channel 4 sorted

18 minutes ago, Bigdave1230 said:

http://www.ross-tech.com/vag-com/cars/levelcontrol.html

This might help 👍🏻

hi yes set height for 123 but 4 says invalid  so cant set 5 drivers side lower than right side 

On 01/03/2017 at 3:31 PM, curlykevs said:

hello to everyone on here i am new on here and need help with my air suspension front drivers side goes up when pump is on but goes down as soon as pump stops i have changed the level sensor and tried to re calibrate with vagcom i go through all the stages save channel 5 the i get no response from control module sso nothing is changed it still goes down on drivers side only fault coming up is pump stop due to over temp put new pump on still the same 2010 Q7  

all hep gratefully received thanks 

i now keep getting invalid when i do put in measurement in channel 4 all others channels ok but channel 4 invalid and then channel 5 says error 

hi 2010 s line v8 diesel i have changed the air pump air bag sensor on the drivers side front but now still dont move and now getting this message on vagcom security access error big red cross controller refused key!
error 22 conditions not correct or request sequence error

hi i changed the suspension air bag and now i get this message from vagcom

hello to everyone on here i am new on here and need help with my air suspension front drivers side goes up when pump is on but goes down as soon as pump stops i have changed the level sensor and tried to re calibrate with vagcom i go through all the stages save channel 5 the i get no response from control module sso nothing is changed it still goes down on drivers side only fault coming up is pump stop due to over temp put new pump on still the same 2010 Q7  

all hep gratefully received thanks