Okay, so I made a mistake and took a day off the car, Went back to basic's.
Turns out quick clear on OBDII does not clear the codes on this car, or at least not the big ones. So I spent an hour with the car running going into each module and clearing codes.
Some codes come back right away, most did not. And now I got suspension again!! all 4 corners are lifted front right is slightly lower than the rest. So either sensor calibration or a leak. But better than nothing!
I still got my handbrake on and it won't come off, the module is not responding to anything, Before the car was sat it was working perfectly fine. So Maybe just a loose connection?!
Almost all codes now are either no response or point back to the ABS or manifold flaps. I have tried to get the ABS clear but again no response from the module.
Is there any other way to get access to this without replacing the part in question?
After clearing engine codes it's running smoother but not right still. I now have an engine light on that sometimes flashes ( when it miss fires ) I am putting this down to the carbon as I can see it on the right-hand throttle body oozing out the left side is new and been replaced. So I will clean it when I replace the manifold and leak test it. Or replace if needed.
My final bit of a hurdle is as some modules still won't respond could this still be an electrical issue? The car was well cared for before the place I brought it from. So there are 2 years where the car was tampered with and poorly maintained/worked on.
Again any tips or things to look out for please just send them my way. As I said before I am not a mechanic so it might seem clear to you but something I might over look.