OJI13

Hi guys, i have 20" wheels with 40/255 set up et 43. So fed up on the road conditions and thinking on going to 18" with 55/235. I have been doing research and just would like conformation on et figures. Am i right that on a A6 C7 allroad 2012 the ET range is 35 - 45. Kind regards Ian

Hi Gareth, Well I've only just seen your reply as I have already checked the fuses on both sides of the side dash boards in situ and all is good which points to like you have said, a broken wire somewhere. Thanks for the advice and I'll will look there tomorrow. Regards Ian

Hi folks, so help please. Only just got around fixing the heated mirrors. Upon testing them both was faulty, zero ohms on connections so got two new ones. Passenger works but drivers side doesn't, no voltage at connections. Where are the fuses for them as looking online, they state there on the dash board panel. They state there on the side of the dash board panel but on looking in the manual no mention of mirrors. Before I take the door card off to look at the module, locating the fuse first I obviously want to try. Regards Ian

That would now make sense as ever since I had arms changed it always ran hard. It was a garage that I have been with for 35 years but things have changed there and they admitted they don't no what to do with this car. I have now moved to a Audi independent garage, that has been rated highly. Time will only tell. Wish luck 🤞

Awesome, thanks for that. Will put that forward to the garage 👌

So far he did a basic setup on what was at fault. I'm thinking and tell me if I'm wrong, to perform a calibration because of having all the sensors changed. Am I right that just changing one sensor you have to perform a calibration. The garage before is where I always taking my car for 35 years but they admit they they don't know what there doing with air suspension etc. Like yourself, I'm thinking it's a module......but which one 😔

So 2 of the hight sensors where faulty. I had all 4 replaced for new as i'm wanting to keep the car so going to change all as i go along......wish me luck but i truly love the car. Anyways, had it recalibrated etc but given a day or so goes back to what i would say, safe mode and feels hard. Now at an recommended independent Audi garage, last fault stated, basic settings required, got the car back, all ok but then again the next day went all hard. I'm using a VDS tool and showing now Headlight range fault. 120589- Function restriction due to other fault modules U1113 00. Obviously going back to the garage just shouting out if there's an obvious route to go down.

Hi folks. I have a Audi A6 bitdi 2012. Had the front and rear arms replaced and knuckles replaced. Picked it up and now drives really hard, feel every bump etc. Obviously going to take it back but any thoughts on what has caused that. Clearly they have done something wrong. I have been researching and some say on changing suspension parts you have to recalibrate it.