-
No lights on dash and no start.
Hi tugg, unplugged clocks for 24 hours and now back working? Thanks for your help mate! What would be the cause of this do you know?
-
No lights on dash and no start.
Hi mate been too busy at work to have a look at it, gonna get a look at it on Monday hopefully can figure it out
-
No lights on dash and no start.
Will put battery on a charge while lifting the carpet up the check. Cheers cliff
-
No lights on dash and no start.
Thanks for reply magnet. I’ve used Napa battery’s for a while and never had an issue but it’s not to say I’ve got a dud battery. yeh hazard flash when it’s parked up and Locked up but no alarm sound. I’ve had a jump pack and still no joy and had a jump start from another vehicle with still no joy. Will put the battery one a full charge today and see what happens with that thanks again
-
No lights on dash and no start.
Car had been sat for ages and battery was goosed. Put it on a charge and voltage dropped straight away. Also tested it with snapon battery tester and said replace. I bought it from napa auto parts stop/start battery. alternator was pushing out 14.3/14.4 once tested with new battery. battery didn’t get coded to the car no. haven’t checked for a drain but lads at work was saying the hazzard were flashing but no noise from alarm? everything was good until it got a wetvac on seats and floors. Guy who done it left them soaking wet.
-
Briggsyyy95 started following No lights on dash and no start.
-
No lights on dash and no start.
I have a 2011 Audi a3 8p 2.0tdi, I put a new battery on Monday and it’s all been fine until today. went to go into the car today and no lights come on dash. Not even the display for mileage, engine turned over started for a second then cut out. Obd is letting me do a scan but when trying to get into immobiliser it won’t connect. These are the codes that I have got with a snapon Zeus — ECU (Engine Control Module) P157000 - Engine Control Module (ECM) Locked P0672 - Cylinder 2 Glow Plug Circuit ABS / ESP Control Module 01317 - Control Module In Instrument Cluster (J285) No Communication Power Steering Control Module 01309 - Power Steering Control Module: No Signal/Communication CAN Gateway (19 - Gateway) 00381 - Databus Instrument Cluster: No Signal/Communication 00474 - Control Module For Immobilizer: No Signal/Communication 00473 - Combination Comfort Databus In Single Wire: Open Circuit Central Electronics / Body Control Module U015500 - Lost Communication With Instrument Panel Cluster (IPC) 00532 - Supply Voltage B+ Lower Limit Reached The car had a full valet on Wednesday. Seats and carpet left soaking wet? Thursday had a new window mech as cable snapped on Thursday been sat for 2 days and now this? anyone had this before could help me out thanks
Briggsyyy95
Members
-
Joined
-
Last visited