Mungo2007

Hi all I need to change the rear shock on my 2007 Q7, if i change with a second hand unit will the shock need to be coded to the car or is it a straight swap? Thanks

Hi Guys I need to replace the swirl flaps on my 2007 3.0 TDI Q7. I need to replace the full set butterflies and seals etc, not just the arm from the swirl flap motor, tried this and still got the engine light. Can anyone recommend a kit for this, i have seen lots on Ebay at different prices but not sure which one to buy, i want to get the full kit not just the blanking kits that you can buy. Any advice where i can source a good quality kit would be most welcom. I am in the UK by the way. Thanks

Hi all My 2007 Q7 has come nasty scuffs on the lower door mouldings on the drivers side it is a 2 tone grey colour car with the dark grey as the body colour and door mouldings a lighter grey. My question is can these be filled and painted? If so what is the colour code and where can i buy the paint i have been looking for a pair of second hand ones but can't find any to match the car at the moment so wanted to try and refurb what i have. Thanks

Hi all I need some help with the wing mirror repeater on my 2007 Q7. The repeater works but VAGCOM tells me there is an error and i am getting that annoying alert whenever i start the car so i presume there is some sort of resistance problem telling the brain it is not working. I took the mirror apart today, does anyone know where i can buy just the LED module part that sits inside the repeater reflector body? Thanks

Hi all Can anyone help with a paint code for Q7 lower door trim the car is a dark grey with lighter grey plastic trim, no idea where i can find a code to get some paint to repaint these trim parts. Any help appreciated. Thanks

Hi All I need to replace the LED in the wing mirror repeater on a 2007 Q7, can anyone point me in the right direction of where to buy i just need the LED part which looking inside the mirror is replaceable without changing the complete indicator unit. Thanks

Hi Gareth Car has been used everyday so i don't think the battery is a problem but i will test this anyway. Ok so the compressor is the first area to look at are there any ways of testing the compressor to see if this is the fault? Duncan

Update - Bad news fault code has come back after a couple of weeks so i changed the swirl flap motor but still got the fault code. Is there a way to bypass this and leave the swirl flaps open and trick the system to think it is all ok? I maybe wrong but i am sure i read somewhere online this is possible and then the fault code goes away.

Hi I need some help with a suspension fault on a 2007 Q7 i have the dreaded orange warning light on the dash, VCDS says electrical fault, the car runs fine suspension is at the correct heights and the adjustment on the MMI all works. Has anyone got any ideas on where i can start looking for the fault? Thanks

Hi all I need some help with a problem i have with a lamp out warning light that constantly comes on to tell me there is a bulb out. All bulbs are working fine had it plugged into VCDS and it is indicating the drivers side mirror repeater is the problem but this is still working ok. Is this just a case of replacing the LED's in the mirror or is there another fix to sort this annoying problem. Thanks

Just thought i would update the thread, looks like problem is fixed for now. After looking at the thread link and some other forum threads i found that the link arms from the swirl flap motors can start to wear in the ball joints, so i thought i would try this fix first. Bought a repair kit on Ebay for £26 but it is an upgraded kit with the full ball joint covered rather than the standard ones that have the back of the ball joint open i thought these may wear a bit more evenly. Popped the arms off of the swirl flap motors on both sides with long nose pliers and popped the new ones on took under 5 minutes, i kept fingers crossed that just doing this would fix it as there was a bit of play on the existing ones, engine management light out plugged into the diagnostic software and cleared the permanent codes coming up run for a few days and all fixed fingers crossed cheap fix, but time will tell if there are any other problems that flag up again on the diagnostics but you never know i am not normally this lucky!

Thanks Steve Another question that i always get confused with it says bank 2, is this drivers side or passenger side so that i start looking at the correct side.

I said in an earlier post i would feedback on the kit i bought. Ordered Thursday and arrived Saturday they do have a website but i got the kit on Ebay. I thought i would start with the Q7 i have that needed gas, kit comes with great instructions but i did have an issue and was not sure on something so rather than cause myself problem i waited until today and spoke to the company about it. GREAT support from them talked me through the whole process while i was with the car. I had to put in a leak stopper can first to seal the system only because the gas was so low you don't always need this (only seals the O rings) then i put the gas can on the system and it is perfect runs nice and cold and done in about 15-20 minutes. I don't normally leave reviews but this product and company are worth it, great product and really good support which is something you don't get nowadays. Not sure if i am allowed to put web links on so please remove if not the web address is http://www.aircontopup.com/ There are plenty of videos online for the products as well so you can see how it works.

Hi all I have a 2007 Q7 that has sprung up a P2011 fault code with from what i can find online is “Intake manifold air control actuator / solenoid, bank 2 – open circuit What does this mean and is it an easy fix? Car is running fine so not sure if it is one i can leave for a bit or need to address it now. Thanks

thanks John i will got through you advice