Boatman Dave

Hi, have you checked the contacts in the "A" pillar male connection? I had this problem on my A3 PA water ingress into the socket had corroded the male pins and caused poor connection. You would do well to check both front "A" pillar looms. Before disconnecting the "A" pillar connector, you should disconnect the battery and wait 10 MINUTES, in the doors behind the card, there is a sensor with a yellow connection, generally speaking, ANY YELLOW CONNECTION IS RELATED TO VEHICLE SAFETY SYSTEMS. Removing the door connector could trick the air bag system into thinking that it's had an impact and deploy the air bags. Regards Dave.

I can make them with wire length of up to 1000mm. The standard length is 300mm for the "A" pillar & 500mm for the Door Conector. If you can send a photo to davecarterboatman@gmail.com I'll check them for you. Regards, Dave.

Hi, Sorry, only just picked up your message, I'm not sure if this part fits your vehicle or not. However, if you disconnect the flug from the socket you'll find a number on the side. Pleas look at the photos. Regards, Dave.

Hi Al, The wire length is approx 300mm on the plug side (DOOR) and 225mm on the socket side (A PILLAR) but I can make them any length you want up to 1000mm for the door plug. I only use "QUADLOCK" pins and contacts. This ensures the best possible contact between the two halves of the loom. I also recommend replacing both parts as some of the wires carry very low signal voltages. Normally they sell on Ebay for £66 for both parts (male/Female). (I was quoted £330 from Audi dealership, this is why I started to make them myself.) However, if you want both side's of the vehicle I'll do them for £100 and free next day signed for delivery. Please note the wires are not the same colour as the original! So care must be taken when making the connections. If you wish to chat via Email: davidcarterboatman@gmail.com Regards. Dave C.

Hi, I'm new to this, I've been searching the net and found this owners club. If any one's interested I can supply Door Loom Repair Kits, using New Audi Connector blocks and heat resistant silicone covered Tinned Copper Conductor they are very Flexible and are multi Variant fitting. You can find them on Ebay but I will give a good discount to club members