Latest Posts

With apologies to Cliff for following on from his question:- I believe you can discount any association with the bonnet contact. If the wipers work, then this is serviceable. If it were mine, I would first be checking you are getting a good 12 v supply to the pump and an adequate earth. If you are, suspect the aftermarket pump, but I haven’t had any frequent issues with these. If you aren’t getting 12 v to the pump, you will need to check wiring back to the stalk - which could also be the culprit. Please let us know how you get on Martin. Regards, Gareth. p.s. Afterthought :- you are talking windscreen washers here, rather than headlight washers- ?

Please help! I have a musty smell inside my car that I can’t get rid of. I have changed the filter behind the glove box and set one of those air freshener bombs off but it’s still there. I have researched the problem on different sites and come to the conclusion that it is the condensation drain pipe that is probably blocked as there is no water dripping out from underneath the car when I have the a/c on full blast at the lowest temperature. Has anyone else had this problem and knows how to remedy the situation. Thanks.

No, the tyre pressures are always okay when checked. It’s not saying that a specific tyre is low on pressure as it would if there was a puncture etc but that there is a fault with the system. I have found out that it is not sensors in the valves that monitor the tyres but a combination of the rolling circumference when set which is monitored by the speed sensors/ ABS system

Hello Martin, We can see you have returned to the forum since yesterday’s post requesting an update. Any good reason why you are not responding?

We have sheep breaking the 20mph limit. Would an App cater for that!?

Welcome Tom. Please do not wait around on here for a response, particularly since your link doesn’t work - well at least for me. This car is seriously trying to tell you something, and if it were mine I would not be using it until it’s assessed by a trusted local garage. Apologies for coming over as being dismissive in this case, but to me, this doesn’t seem to be a candidate for remote diagnosing, but needs to be seen and assessed. Kind regards, Gareth.

Evening everyone, newbie here. Just purchased a 2015 Audi S7 V8 450bhp petrol with 96000 miles, lovely car but has just thrown up the error on my ODB2 o2 sensor signal stuck lean; bank 1 sensor 2. Is this an easy fix to do at home, or a garage job? If it can be done at home where can i find it? Thank you.

Thank you I will do

Hello Does anyone know the part numbers for the red front brake calipers on the S6? From doing some searching I found the numbers 4N0615107AG and 4N0615108AG, but on some sites they are referred to as being for other cars like the SQ7 and S7. Are they the same part? Thanks

No out of place noise, just normal jerk as if you let go off the gas and got back on immediately.

Hi All. Would really appreciate some support with an issue that has confused audi specialists. The MAF sensor keeps on blowing. When it does the car cuts out. Unplug the sensor, the car runs ok, but over fuels. Putting a multimeter on the ground pin in the wiring plug, the next to the middle pin I get 4.99 volts which I think is correct. If I them check the next pin I get 7.3 volts with ignition on and 9.5 volts with the engine running. I thought this was supposed to be considerably less? If that's the case any ideas where to start? Anyone know where I can get a schematic for the actual ECU? I'd like to track back through the loom and find where the excessive voltage is coming from. All help will be very much appreciated. Stu

Please let us know the outcome. Note that this is a forum in which information is supposed to flow two ways, so we do expect some sort of acknowledgement or response from members to those who having taken the time to answer without us having to nag.

Take it back to the dealer with your mechanic's report. The dealer will undoubtedly try to dismiss your problems with all sorts of excuses, but stand your ground and insist on either a refund or a full repair. It's your legal right.

Glad to hear it.

Yes stays at 90. When the EML comes on, if you stop then restart, that journey also stays at 90. But on the one occasion the EML came on and we didn’t stop/re-start, it went just above 90 and fans were blowing hard. That’s what made me finally book it in. Error code is P00B700

If that was really true don't you think Audi would have supplied their cars filled with a high viscosity oil at the factory? There are very good reasons for a specific quality of oil being chosen for a particular application, so it would be foolish for a novice to even consider changing to something different if it does not match the original specification.

Just because the casing or outer box is identical from one model to the next, does not mean the gear ratios inside are also identical.

I've switched from Tesla to Audi and have subscribed to Tesla Charging for non-Tesla EV's which seems to be the most cost effective DC charging option out there. Does anyone know how to plan a trip on the MMI to charge at those Tesla chargers open to non-Tesla EV's - I was just thinking about ensuring the battery is prepared for charging. Thank you

Recently joined this Forum and have found lots of useful information on MMI not working but unfortunately cant get mine to work yet. Car is a 2012 Audi Q5 2.0 TDI S Line UK Car. Steps so Far - Checked 5A MMI fuse front passenger side and 7.5A fuse in the boot - Checked Radio unit in boot and MMI head unit at front both have power and ground supply - Used an optic bypass on the radio and head unit - Charged the battery which was reading 13v on multimeter after charge and also coded in using VCDS - Changed the centre console panel - Used VCDS Optical Bus Diagnostic which showed 19-CAN Gateway, 5F Information Electr.(High/D3), 56 Radio all ok both electrical and optical - VCDS also could not reach 5F or 56 when I ran an autoscan which seems to contradict the information above? - VCDS also showed a 00384 - Optical Databus fault which I'm assuming is part of the problem? The only other thing I can think off is order an MMI head unit from Ebay and try that but any other ideas would be appreciated

Hi Did you ever get this sorted out ? I’m having exactly the same problem?

Hi, I have gotten my new audi A1 2018 car a few days ago. I have been trying for several days to connect my phone to the bluetooth however when clicking on the “telephone” option on the main menu it states “ telephone is not installed”. My dealership stated that I would just need a SD card and that I would need to sort out my connectivity with audi themselves. Was wondering if anyone could help with any other quicker solutions at all as i don’t entirely believe what i have been told

Welcome to the forum you'll find the members on here are a friendly and helpful bunch 🙂

Ok Dave, many thanks.

Thank you. I believe it was low fuel pressure, changing the fuel pressure pump (I’m so rubbish with cars as you can possibly tell) under the back seat did nothing, the guy at the garage said he thinks it now could be the ecu, they checked for any visual damage to it and nothing, I spoke to someone who deals with ecu’s and remapping and he said he doubts it is that

Where was the car parked while you were away mate? Just wondering because there have been a lot of horror stories in the press recently about airport parking companies using (and often damaging) vehicles while the owners were away.