All Activity

Hello John, ’I got the passenger side … joint replaced’. My advice would be to take it back to whoever fitted it - don’t fiddle with it, don’t try to self diagnose it - but take it back ASAP. Please let us know how you get on. Kind regards, Gareth.

Genuine Audi RS4 Black diamond cut alloy wheels and tyres some but not many at all minor scuffs/age related marks but in overall great condition for age. 275/30ZR20 - OE part number 8W0601025DT They all come with tyres 2 have on Pirelli PZero with 4.5- 5mm of tread 2 have Nexen with 7.5mm - 8mm of tread Would much preferably sell as a set, £2,200 ono Please feel free to contact me with any questions, can deliver at a cost depending on distance but collection in person is preferred Thanks

Tim. If you look through the forum history you will see that changing from tungsten to LED is far from straightforward, and sometimes impossible. If your lights are dim it would be simpler to just renew the bolbs. Incandescant lights do become dim over time.

John. You have only done one CV joint so I would suspect the other side also needs to be changed. They tend to wear out at the same rate.

I fitted these P21w 1156 Ba15s LED Bulb White 6000K 6W 12V-24V DC10-30V Super Bright for Reverse Light Brake Turn Signal RV Interior Light Auto Backup Rear Fog Lamp Stop Drl Tail Position Bulbs Rear Fog Lamp 2 Pack : Amazon.co.uk: Automotive Absolutely no problems or errors and they're a huge improvement over the originals, like day and night (no pun intended. My A6 is a 2003 though so possibly may not be as fussy as newer models?

Is there a link for the stickers please

I’m about to start looking for an SQ5 between 2017 and 2019 and I’m undecided to which engine to go for was hoping to get some feedback on reliability between the TFSI and the TDI many thanks, Alan Reed

The longer you drive with a defective clutch you run the risk of damaging your DMF which would cost you alot to replace, I would change it sooner rather then later. My biting point with old clutch and new clutch is smack in the middle. Sacs clutch’s like what will be fitted to b9’s shouldn’t experience bite point travel, they usually just start slipping once all travel is used

Have you checked your serpentine belt as may be contaminated with antifreeze which would cause slippage under load.

I got my 2.0TDI B9 quattro timing belt changed + the waterpump and when I got it back going uphill the car squeals its quiet unusual.

Hi All my car is a 2010 1.4 tfsi 3 door has anyone successfully used a led for rear reverse light ie no warning on dash (canbus error) if so what bulb did you use? many thx in advance Dave

update again here is a read out for now on the battery until i can find somewhere to have it fully checked over

update this is what a scanner is saying should i still go down the route of a battery cannot get into a garage some i wont touch

I bought another replace screen that definitely works but it still had the same probably and I’m not sure what else to do?

Welcome to the forum you'll find the members on here are a friendly and helpful bunch 🙂

Please contact Trevor the Audi owners club administrator. His user name is Audi owners club. As the club is managed by a limited company I suspect you'd be in breach of copyright. Trevor can send them out to you

Hi people just wondering if any of you have changed the front fog light bulbs to led? I am looking at various ones mainly because when the fog lights illuminate my way to my door they are quite yellow and I would like them a lot brighter/whiter. Any suggestions please , if I choose some I will take before and after comparison pictures, this may help others in future. Regards Tim

Would I break copyright if I asked my local vehicle sign writer to replicate these for me? I would have them done with peel off application paper as others in the group have suggested

Hi people just bought a 2010 A4 Avant Changing timing belt and water pump before I use her until, for my own sanity. I owned an A5 3.0 v6 Quattro coupe a few years back which I loved but needed a replacement work van so she had to go. Always liked the A4 avant style so that’s what I chose this time round. Looking forward to being involved with chats etc with you guys regards Tim

Did anyone get to the bottom of this problem as we are now experiencing the same thing?

Luckily it's going into gear ok so don't think it's the gearbox , it's seems to be when I start to move while in drive or reverse, so it feels to me like something lose and knocking, im starting to think about lose driveshaft bolt .