All Activity

did you ever get the fix?

I have have a 1990s Cabriolet with black carpets but I fancy some original beige carpets were changed. I've no details of the original car's spec but could there be any code number on any chassis plate which tells me what colour original carpets were? Regards Nigel

2008 a3 Quattro s line I am already aware that the inlet manifold needs a change and so I am pretty sure this is the cause of my issue - however just to be sure I thought I’d ask When reversing after a long drive, I will stop the car infront of my drive and put it into reverse. I then notice that my revs are super high before the car starts to move backwards and it jitters - around 4.5rpm approx. Could this be the manifold? (Getting changed sometime next week) or some other issue? Thanks

If you can hear the solenoids then it would suggest your switch is working fine. My first step would be to check the level of the hydraulic fluid in the convertible roof motor pump. If you’ve not done that before it’s in the boot on lower right hand side. You’ll need to remove the interior boot trim to get to it. Alternatively, perhaps the handbrake switch is defective / stuck?

Hi I'm getting close to buying a new 2025 A3 1.5 TFSI 35 Black Edition Sportback. I'm in the UK. It will replace a 10 year old Ford Focus. Can anyone help me out with a few questions I have? 1) I don't really like all the data they collect via the in car eSIM (similar with any new car these days). I guess there's not much I can do about it? 2) I don't plan on using any apps, connecting smartphones, paying for services first 3 years or after. Is that going to cause me issues? 3) Is there any generally known common things with this vehicle I should consider before buying, or when checking the new car when it's ready? Many thanks!

What was the outcome ?, what did they replace & did they say what was causing the noise?

Any comments so far Bob?

Thanks

Hiya folks…. Apologies to reply to, and drag back up to the top an old thread. I’ve not seen any other threads like this (but it has been a long week!!) is there a way around this? Code it out or similar? Every trip for almost two years now I have to change from efficiency drive mode to something else and back again to fully get efficiency mode gearbox (with intelligent free wheel etc…. I’ve poked around in VCDS but I’m very new to it. I’ve done basic settings and addressing of some heater flaps and I felt very smug at achieving that much 😂

Just purchased my 2021 E-Tron 50 and my AC has the same behaviour. It comes on initially and then stops working after a minute or so. I have a 60 day Arnold Clark warranty and i actually purchased an Audi extended warranty that starts in June too. Seems to be a pretty common fault unfortunately and bad timing with the current weather :-(

Driving the car back on a 12 mile round trip and the ‘checking engine light” came on. The car is a 3 yo A6 C8 40 TDi with 15,000 miles on the clock.Any ideas on what to check first? Is this a sensor fault or soot build-up? Thanks in advance for any gen

Hi, would someone please help me out with correct settings for Bluetooth in the green menu, as I stated in a previous post I went a bit giddy in the green menu last week and everything is now either not working or blacked out. The Bluetooth simply isn’t working so some help would be very much appreciated.

So... Camshaft magnets done, car insured again, idles smooth and knocking noise gone quiet Gone to take car into a friend's bodyshop (5 mile drive) Knocking nose starts again just down the road from bodyshop and starts running rough, sounds almost like metal on metal, plugged diagnostic in and cylinder 4 misfire. Compression test shows (from 1 to 4) 175 - 175 - 175 - 150. Looks like im going to need a new engine at this rate 🤔 🙃

as i posted ...above

Hi guys, air blower not working on my 2010 SLine TDE. The lights come on, but no and the dial goes up and down when adjusting it, but blower not kicking in, took blower out and it spins freely, guy at scrap yard checked it and said blower motor is fine, ordered a new resister and fitted it, but still the same, ( I suspect the new resister is faulty). How can i test the resister to see if its working or not? And if resister is ok what else could be the problem?? I have check fuse and thats ok. Thanks

Has it got an SD card slot. If so I can recommend https://www.navboost.co.uk/. I upgraded my wife's 2017 A3 to include apple airplay using the software this company provided. Even though I had a few issues (which in the end turned out to be my fault and using the wrong cable) the customer service was astonishingly good.

Thanks Steve, that's a logical starting point. I'll see what I can find through them

What was the fault on urs then, what was replaced??

tahts pretty much the same sound as mine. as previously posted above, I had a few parts replaced and it was pretty much sorted but very ocasionally, it has started to do it again. im watching this thread with interest. fingers crossed your Audi specialist solves it for you. hope you post back here with their findings.

No reason but I'll defo try PIM next time I need something.

A faulty wheel speed sensor

Một cảm biến tốc độ bị lỗi ( của 1 trong 4 bánh xe )

Done

Guys !! regarding the creaking noise on the left side front. It only happens when I turn left slowly when parking up etc… I’ve had top mount, ball joint, track rod end and drop link replaced but the issue is still there. I’m sick of spending and not getting to the issue. I’ve booked it in for a diagnostic with an Audi specialist next Friday. The mechanic who’s done the previous jobs advised to do that. I’ve added a video with the sound of the issue. If anyone has had the same issue any advice would be appreciated. Someone has said change tie rod arm. IMG_7325.mov

Yeah was gonna do this. Don't fancy chasing wire all all around the car. Done that years ago in an old E30, that was ok because they didn't have the speakers in the doors just in the front kick panels and rear shelves. Plus not replacing the whole system like I read some have done, just the speakers that have blown. I actually quite like the sound in our A4.