Beany1

Got an audi a4 b7 2.0 tdi bre engine got vibration at idle checked on vcds my torsion value is -3.6 is it supposed to be close to 0 can anyone adjust this for me thanks

Hi thanks stevey i put in reg no and it comes up with this mount but my y bracket is slightly different so im thinking i can swap out the rubber mount and use it on my original y bracket because the rubber looks the same

Seen some transmission mounts on ebay but the y bracket look different can i take the rubber mount part off and put it on my original y bracket

Got an audi a4 b7 2.0 tdi 6 speed manual does anyone know which mount i need thanks

Hi can you send me a picture of the mount please i need one too thanks

Hi did you find the right mount i need one to thanks

Hi mine is the bre engine so do i need the 7v ceramic ones thanks

20230522_065913.mp4 20230522_065841.mp4

Hi steve yes had someone yesterday on vcds vagcom it only came up with p0674 for cylinder 4 glow plug apart from that he said everything was good full health check all sensors everything working air flow all good injectors within spec the only thing is injection value bouncing around 1.5 to 2.5 mg and it says it supossed to be around 3.0 to 9.0 mg is there anyway a tuner can sort that out thanks

Hi injection quantity is bouncing around 1.5 and 2.5 mg it supoossed to be around 3.0 to 9.0 mg what could be the problem all 4 injectors are reading within range audi a4 b7 2.0 tdi 2006 thanks

Hi putting new throttle body on car can i just put it on and drive or does it need adapting audi a4 b7 2.0 tdi bre

Hi does anyone know which fuel pump i need for audi a4 b7 2.0 tdi 140 bre engine 2006 thanks

Thanks steve had a look at forum and few videos and it looks like its behind the oil filter housing on the right hand side like you said . I will take a few things apart tommorow and have a look thanks for help

Hi im looking for the crankshaft sensor too cant find it audi a4 b7 2.0 tdi bre any help please

Hi steve checked everything no code the fuel pump is working battery and alteenator fine thinkinking its the crankshaft sensor do you know where it is thanks

Where is crankshaft sensor on an audi a4 b7 2.0 tdi any help please

Hi have a a4 b7 2.0 tdi car cut out while driving now wont start it is cranking but wont start if anyone can help thanks

Thanks steve was just going to put 1 in as i only have one plate so is it ok as i showed on the picture thanks

Can i fit it here

Hi had egr mapped out where do i put the blanking plate

Ok thank you steve any suggestions on a single solid mass flywheel instead of the dual mass

I have an audi a4 b7 2.0 tdi 6 speed manual will an audi a3 clutch and flywheel fit my car

Ye thanks for reply will call audi in morning and get more info cheers