a6blacked007

Could this wire be why am getting all my faults on dash not sure what it is speed sensor ?? 

 Kind regards mark 

I think it's should be plugged into auto handbrake still works until all lights pop up on dash 🤔

11 hours ago, anthonywalker198734 said:

Thanks for all the comments on the suspected issues of what it could be I will inform people of what the mechanics says tomorrow 

1st things 1st you need it scanned and see what codes you've got and go from there ... 

9 minutes ago, Magnet said:

Thanks for the frank comments Mark. 
Your comments put me in mind of the late Tommy Dewar (of Dewar whisky fame) who said:-

‘ If we are put on this earth to help others, what are the others doing to help themselves?’

Kind regards,

Gareth.

 

Your welcome Gareth we all need a little helping hand including you my friend 👍

22 hours ago, Magnet said:

Please tell me if you think I’m being harsh by commenting that time effort and experience has been devoted here to no avail since the OP simply hasn’t returned to view any responses.

Let’s hope he’s OK.

Kind regards,

Gareth. 

Is a bit ott Gareth were all here to help each other in the audi world if you want to try and help do so but give people a chance they have lives outside of the forums buddy. 

Rotated my wheels 

Sure it's not abs as lights would be permanently on dash speed sensor wire maybe 

Anyone know what the middle wire is in this picture its snapped off on my rear drivers side hanging down.

Ones with round bits on them 

Tagged you in 3 posts @anthonywalker198734

This is what I have narrowed mine down too 

Yaw rate sensor 

Battery (done) 

Wiring issue (cut or rusted out)

Abs sensor 

@anthonywalker198734

@anthonywalker198734

@anthonywalker198734

Hi @anthonywalker198734

Same issue as few of us still going on in my car check out few of these posts 

2 minutes ago, a6blacked007 said:

Currently drying my boot out plenty in there with current rain, my dash light issue has been worse than normal, wondering if this is cause ... 

part 56 I believe ..

Currently drying my boot out plenty in there with current rain, my dash light issue has been worse than normal, wondering if this is cause ... 

On 4/21/2023 at 3:45 PM, IWalt said:

The latest on water in the boot cavity.

I have found that you can buy a gasket to attach to the edge of the boot lid, see photo. I purchased it from the local Audi dealer for £21.88. and fitted it in about 15 minutes. Making sure that the paint surface was cleaned and dried using white spirit. The part number is 4G5827321 Gasket. I also purchased two Bumpers 4H0827589B which I thought I might need. Only 59p each but found that the gasket already comes with its own. The gasket arrived broken in two which helped when fitting the gasket to the boot lid. Not sure how hard it would be to fit the gasket in one long section. A warning if you decide to fit this gasket, once the adhesive strip touches the bodywork, it sticks, fast and very strong. And you will have trouble moving it. I did this fitting by myself, but it may be wise to get someone to help.  Anyway, after all that I am now waiting for a good downpour to see it works. Will post an update ASAP.

(I wonder if this is an upgrade fitted to later A6’s)

Regards

Ian

Update please mate

6 hours ago, Etch said:

Dear all,

I see some of you are managing to take your rear seats out (thanks for the image of the module/unit under the seat, that helps to know what to look for).  A few months back I tried to get my seat out but could not do it.  Have had a spine surgery since then so only just getting around to trying again.  Today I made another attempt after reading manuals and watching you tube vids, still can't; do it.  I can tug up on the seats and hear the latch unclipping but that's it, the seat is just locked in place, can't pull it up any further, can't slide it out.

Any tips on how to get this seat out would definitely assist.

Take out isofix plastics at rear push down and out then pull up front of seat clips with probably break few quid on eBay replaced mine.

No never looked into it yet is annoying tho ... 

Hi Steve no code's at all and still works perfectly. 

Strange one ... 

Hi guys

I keep getting child proof lock fault when I start the car if I press button it dissappear's anyone had this issue. 

5 minutes ago, DarrenJC said:

Did the LUK kit for £750 include the dual mass Flywheel and if so, can you remember where you got it?

Yeah that was everything Its 1 full unit buddy can't buy it separately apparently clutch was ok it was dmf knackered knocking badly when a was slowing down.

Also judder when pulling away. 

Garage got luk kit not sure where from.

I got luk kit on mine 1000 miles ago £750 with release bearing fitting £350 all in £1100 apparently nightmare to fit.

We're is this sensor located?