Fatbloke

A wee bit further info. I had an issue on my Skoda VRS where the fans etc were working but no heat on passenger side vents. Turned out to be a thermistor in the vent pipe was reading high temp so hot air flaps didn't open as it thought it was already too warm. Replaced thermistor and all working again. Info just in case someone else has a similar issue.

The haldex and transfer box are separated and take different oils. They do not share oil.

My 2016 gets around 46mpg average. Remapped from 150 to 190bhp. Only time I have seen a big mpg drop was on a car years ago was because a brake caliper was sticking on a bit. If nothing obvious with the engine, check the brakes are OK.

I changed mine a while back to spray rather than jet. They were already heated. I think the heated spray ones were ofor an A6 if I remember correctly.

Shocking that they said its a wear and tear item especially when it involves fuel. If it was wear and tear, it should be in the service schedule. They will know about this and deny its an issue. They did the same with my electronic handbrake issues for 2 and a half years until it was out of warranty. Sounds like usual fob off from Audi. Very disappointing.

There used to be an issue with Skoda Octavias a while back with the geometry settings causing the rear tyres to quickly feather on the inside edges causing a droning noise. We had this on our VRS and it sounded like a failing wheel bearing. Skoda revised the rear geometry settings several years back and its been fine since. We did take it to the dealer twice and both times they set it incorrectly so we took it to a local specialist and it was fine. We use the specialist guy every time now. Run your hand round the tyre edges and if its smooth one way and really rough the other way, they are feathering instead of there being even wear.

I have an h+r -50mm cup kit on the Skoda VRS (actual drop on the Vrs Was around 35mm) and it made a massive difference but the springs a slightly harsh on rough roads. Eibach springs are a bit more forgiving so I went with the Bilstein shock / Eibach Sportline springs option for the A3. It should lower it around the same 35mm drop. Currently the A3 is not too bad but I find it a bit wallowy compared to the VRS. I would assume but don't know for sure that the standard suspension and 17' tyres would be even softer but don't have any experience of it.

I have the 18" wheels and sports suspension on mine. Its not too bad but a bit bouncy and wallowy on corners. I am about to replace my suspension with a Bilstein B12 Sportline kit and front and rear Eibach anti roll bars to improve the handling and driving feel.

Got a k+n 33-3005 in my tdi 150. No problems at all. Cheapest I found was amazon but the price is up to around £53 so shop about.

Just got my 150bhp tdi remapped to 190bhp. Torque up to 430 n/m. Much better.

Can you get these covers for the 3v sportback?

I have seen other posts about that happening. My warranty is expired now and none of 3 different dealers ever fixed the issue. They just deny all knowledge that there are issues with these handbrake (even when it stuck on in the dealership car park). I hope you can get it sorted out.

If the EML comes on it should hopefully have stored some error codes. VCDS will read them (there may be someone on here in your area that has it) or a cheap ODB2 reader may show some if not all of them. You need the codes to start narrowing down what the issue is.

Any errors?

Some of the A3's have them seemingly. Probably other models too. Other VAG's use them also. Its silica or something in them to boost the properties of the coolant as far as I understand. Some people remove them to prevent them bursting.

Mine is "notchy" going into 2nd. Initially the dealer adjusted and the synchromesh was mentioned. They eventually said it was "normal" without fixing it. Fob off.

Some vehicles have a perforated bag of beads in the coolant expansion bottle to boost the coolant. These have been known to burst and the beads clog the heater matrix. Check to see if yours has a bag and if its intact. More than likely it's an airlock somewhere and the system needs bled, thermostat issue or water pump issue.

Car in again today. Still no fault found. Still no fix.

I am still getting this intermittent issue. It's quite dangerous and has nearly caused an accident a few times. The dealer has had it in on several occasions and witnessed it but still no fix. It has now caused a shudder from the clutch and flywheel and it was in to get an oil leak checked recently and they reported that the rear disks and pads needed replaced as they were scored and worn. Nearly £400 to fix. Audi UK are not interested.

I have the same vehicle and want to de-chrome also. I was going to get the front grille and window surrounds wrapped. I just need to decide matt or gloss black finish. I am also going to remove the rear A3 and TDI badges but keep the small quattro badges.

Here's an example but check and get the correct one. You may even be able to see the part number on the one on your car. https://www.ebay.co.uk/itm/GENUINE-VW-AUDI-SEAT-SKODA-2-0Tdi-TURBO-WASTEGATE-ACTUATOR-REPAIR-KIT-03L198716A/191828163664?hash=item2ca9d97c50:g:9gkAAOSwAuNW6X5y

You can also test it by taking the vacuum hose off (at the N75 valve end) and sucking on it. Stick your tongue on the end and see if it holds the vacuum. If not, it's goosed. Check internet on how to test it for further info.

Had a similar issue on the Skoda VRS. You can purchase a separate genuine actuator at a fraction of the cost. I think mine was in the region of £150 or less.

Don't know if you have kwikfit in your area but they will connect the Aircon to a machine that removes the old refrigerant and lubricants, does a vacuum test for leaks and refills the refrigerant and lubricant. If is still doesn't work they don't charge you. If you are sure it's this specific valve, where is that? Is it on the compressor pump? I got a brand new aircon pump for the VRS for £156 off eBay, fitted it myself and kwikfit recharged the system for £50. Aircon is running great. I would find out more about this valve. See if you can get a reasonably priced replacement and check out if you can fit it yourself or get an indy specialist or Aircon company to do it.