All Activity

Any comments Paolo? Regards, Gareth.

Hello Paul, Battery needs to be replaced. Bought from a trader? Regards, Gareth.

Hello Jake, I would agree with your assumption, but an assumption it must remain until inspected. Regards, Gareth.

Good morning I would be eternally grateful if anybody can help with a very annoying issue I have with the air blowers. When I set the blowers to the dashboard vents, air comes out of the passenger side and middle vents but not the drivers. Instead the air comes through the footwell vent on the drivers side and not the dashboard vent. To make it even more confusing, when I set the blowers to to the footwell it stops coming out of the drivers side and only comes out the passenger side. I assume its some kind of distribution flap motor or something. Does anyone have any idea or can help. Thank you

Hi Steve, Thank you for the reply! By reseting the trans you mean I should go trough the "pedal" method? Which method should I use? Last time it didn't work for me or I just couldn't feel a difference in the trans' behavior. I also have a VCDS so I could use that as well but I'm not sure if it's a great idea for me to do so. Also I guess I might be kind of a bad guy in this as well because in the past few months I've barely driven it on motorways or main roads and it was a combination of city drives and driving to neighboring cities that are 15mins from me. When the MTF/ATF oil changed was done they redone the adaptation and the car was a dream back then. Thanks!

Car is 2015, Ive only had a few weeks so guess battery could be orginal

I have had the system run on VCDS and this was the output: Address 08: Auto HVAC Labels: None Control Module Part Number: 8X0 820 043 B HW: 8X0 820 043 B Component and/or Version: Klima 1 Zone H12 0070 Software Coding: 3420080040 Work Shop Code: WSC 00046 790 00000 ASAM Dataset: EV_AirCondiFrontAU210 006035 (AU21) ROD: EV_AirCondiFrontAU210_006.rod VCID: 3365AACB9A3561070E-8066 7 Faults Found: 0005 - Motor for Central Flap B11AB 07 [00001000] - Mechanical Failure Intermittent - Confirmed - Tested Since Memory Clear Freeze Frame: Fault Priority: 3 Fault Frequency: 2 Reset counter: 105 Mileage: 156728 km Date: 2024.10.12 Time: 09:15:09 Voltage terminal 30: 14.2 V Inside temperature: 12.2 C Outside temperature: 12.0 C Central air flap motor: actual value-Data: 0.0 % Central air flap motor: spec. value-Data: 48.6 % 0008 - Position Sensor for Motor for Central Flap B11AC 15 [00001000] - Open or Short to Plus Intermittent - Confirmed - Tested Since Memory Clear Freeze Frame: Fault Priority: 3 Fault Frequency: 2 Reset counter: 103 Mileage: 156728 km Date: 2024.10.12 Time: 09:14:18 Voltage terminal 30: 14.1 V Central air flap motor: actual value-Data: 0.0 % Central air flap motor: spec. value-Data: 100.0 % Supply voltage for external components: 5.0 V 0040 - Function Restriction due to Faults in Other Modules U1113 00 [00001000] - - [New feature! Extended UDS fault detail is only supported by current gen. interfaces] Intermittent - Confirmed - Tested Since Memory Clear Freeze Frame: Fault Priority: 6 Fault Frequency: 2 Reset counter: 112 Mileage: 157141 km Date: 2025.02.07 Time: 22:04:42 Voltage terminal 30: 10.5 V Outside temperature: 7.5 C Inside temperature: 13.2 C 0051 - High Pressure Sensor B10AE 84 [00001000] - Signal Below Allowable Range Intermittent - Confirmed - Tested Since Memory Clear Freeze Frame: Fault Priority: 2 Fault Frequency: 11 Reset counter: 40 Mileage: 156591 km Date: 2024.09.18 Time: 15:29:10 Coolant temperature: 52.50 C Inside temperature: 41.6 C Coolant fan activation: specified value: 0.0 % Engine speed: 0.00 /min Refrigerant pressure: 1.0 bar Compressor current: actual value: 0 mA Outside temperature: 24.0 C 0060 - Engine Off Timer Performance P150A 00 [00001000] - - Intermittent - Confirmed - Tested Since Memory Clear Freeze Frame: Fault Priority: 7 Fault Frequency: 3 Reset counter: 114 Mileage: 157141 km Date: 2025.02.10 Time: 00:08:19 Voltage terminal 30: 11.7 V Terminal 15 status: On 0071 - Running-in regulation B10C6 54 [00001001] - Missing Calibration / Basic Setting Confirmed - Tested Since Memory Clear Freeze Frame: Fault Priority: 3 Fault Frequency: 1 Reset counter: 88 Mileage: 158535 km Date: 2026.06.17 Time: 09:27:06 0143 - Rerigerant Pressure Sensor B1282 14 [00001001] - Open or Short to Ground Confirmed - Tested Since Memory Clear Freeze Frame: Fault Priority: 2 Fault Frequency: 12 Reset counter: 76 Mileage: 156591 km Date: 2024.09.18 Time: 15:29:08 Coolant temperature: 52.50 C Inside temperature: 41.6 C Coolant fan activation: specified value: 0.0 % Engine speed: 0.00 /min Refrigerant pressure: 1.0 bar Compressor current: actual value: 0 mA Outside temperature: 24.0 C

Thanks for the reply, Audi technical recently resolved this for me, not sure what they did as they did not give me anything apart from ‘Our technical support team have made an adjustment’ I then connected to the car again and the apps were then available to purchase again. Thanks for the suggestion and I did try a second device but with the same error.

Try LLL parts You can get the inserts on eBay too. For the other readers, they are held in at the back with a small plastic clip and if you use a trolley jack and don’t line it up correctly the insert will pull out and damage the clip. Then they wobble and fall out.

It would help to know the mileage on the vehicle mate. The pads should do about 70k miles. Discs twice that.

Have you tried using a second device?

So much for the promises of updates that might help others in the same position as Wayne.

Personally I would change them. The old oil will give you a chance to detect metal particles, while if it is clean you will have only lost the cost of the oil. Nobody ever had a breakdown as a result of changing oil too often.

I’ll bear that in mind, thank you.

Hi I would from these figures assume the battery is well on its way anything below 85% SOC and with availability of 25AH is definitely wrong, how old is the battery? Steve.

Hi Folks, I have a 2019 Audi A4 B9 with the following NMI software: MHS2_ER_AU_P2035 0235 Navigation database V03959802LD 0038 ECE 2019 Media driver DEV_MCM_AU_ER_G21_045P… Could someone tell me if there is a later update for my vehicle? Not too worried about the maps as I use Google Maps. If so, where is the best place to get the update from? Audi dealer? NMIUPDATES.COM? Would appreciate any advice in this area. Thank you for your help. Kind regards Paddy UK

Loss of stop/start and radio presets are typical of a dying battery. Get it tested on deep discharge equipment, and if a new battery is needed get it coded to the car.

Hi all, Hope everyone is well.. i have had a problem over the past week with my a3 2.0 tdi sportback. To cut a long story short, drove out to bath for an appointment, had the appointment and got back into the car to notice it wouldnt start first time. After several attempts and long cranks it started but seemed to be running lumpy on idle. Any suggestions please to what this could be?? Mileage is 94000. Many thanks.

Hi I just changed battery on my a4. I have put in a bosch battery without BEM Code. I programmed it with mucar tester, where I just changed the 3 last numbers. When i try to change the clock in the dash, a lot of fault coming i the dash, when the computer have shown all the failures, they Are gone, and Will first Come back when i push the SET button Again.... It comes with a faulure l2 4/4 at the trip spot. See picture I have tried to remove the minus for 10 minutter, and delete the failures with odb. But the failure keeps coming...... What to do?

Got VCDS figures now if any help: Engine off car not used in over 2hrs Voltage (Terminal 30) 12.10V Battery Current -4.6A Battery State (of charge SoC) 62% Battery Ageing (Derived fr.Load) 54% Battery Ageing (Derived fr.Output) 51% Internal Battery (Resistance-Actual) 5.4 mOhm Battery Cpacity (actual/available) 25.Ah Engine On Voltage (Terminal 30) 13.50V Battery Current 12v Battery State (of charge SoC) 62% Battery Ageing (Derived fr.Load) 54% Battery Ageing (Derived fr.Output) 51% Internal Battery (Resistance-Actual) 5.4 mOhm Battery Cpacity (actual/available) 25.Ah

this sounds like one of the flap actuators. I’ve had 2 audi a3’s and both have had this issue. Very annoying problem. If you have an obd 11, give it a scan and it should tell you if your flap motor is bad.

Hi just try a gearbox reset that may well help with this, having the DPF cleaned won't affect the gearbox, normally after a gearbox service they do a reset so all the mechatronics can relearn its values. Steve.

Hi All, Car : 2015 A5 2.0lt 150hp Couple of issues so far. Had car around 3 weeks, had ATF & Filter changed Friday as history shows last change 40,000, car has 98,000 on it Particle filter warning came on dash, took car for spin down motorway but couldent get it start regen, but cleared code and checked soot levels via VCDS and seem ok Other day I disconnected negative terminal in battery to do full system reset, all went well until this morning, start car and get ECS fault, test battery at terminals eng off, 15.7v, engine on rises to 17v Should I fully disconnect battery to try again or does it sound like battery issue just got VCDS but not sure how would test battery with it. Will say previosult start/stop was disabled when started car, after batt disconnect start/stop was auto enabled until this ECS fault, after I cleared that start/stop is again auto disabled (fine by me), not sure if related. Update, used VCDS to clear fault, and been out in car and fault not come back on, but strangly lost some DAB radio stations normally listen to. Oh 1 other thing, when took on motoway when I used the flappy paddle to drop gear, it would only hold gear few secs before going back into normal auto mode ie. D/S depending.

I wouldn’t bother changing the oils in the diffs and transfer box, they’ll be like new. Certainly at that low mileage.

Hi everyone, I have a 2013 Audi A4 B8.5 Avant 2.0 TDI 177PS quattro with the 7-speed S tronic gearbox. I would like to ask for some opinions from people who have experience with this drivetrain. The main thing I notice is that on A-road/main road driving, especially around 55–70 mph (90–110 km/h), the gearbox sometimes seems to hunt between 6th and 7th gear. It mostly happens with small throttle changes, slight inclines, or when I try to maintain a steady speed around 60–65 mph (roughly 100 km/h). It feels like the car is not fully sure whether it wants to stay in 7th for economy or drop back to 6th for more torque. If I drive a bit more positively or at motorway speeds, the car feels great. Above about 70 mph (110 km/h) it is smooth, stable and the gearbox feels much more natural. The issue is mostly in that light-load cruising zone on main roads. There are no warning lights and no gearbox fault messages. When I bought the car, the gearbox behaviour bothered me more, but a throttle/pedal reset seemed to improve it quite a lot. Later the S tronic oil service was also done, and that improved the overall feel as well. At the time I was told that this is more or less normal behaviour for this gearbox/drivetrain, so I accepted it. The car also recently had a professional DPF cleaning/refitting job done. No DPF removal or performance remap as far as I know, just cleaning and related work. I am not sure if this is relevant, but I thought I should mention it in case DPF condition, regeneration behaviour, engine load, ECU adaptation/reset, or torque request could have any influence on how the gearbox decides between 6th and 7th. The gear hunting itself was not completely new after the DPF work, but I have started paying more attention to it recently. I also sometimes notice a slight bump/jerk in stop-and-go traffic when accelerating with the queue and then lifting off the throttle to let the car slow down on engine braking. It is not a huge bang, but it can be felt as a drivetrain knock/torque reversal. It seems worse in situations where the car is crawling and the throttle is applied and released repeatedly. My questions are: Is this 6th/7th gear hunting around 55–70 mph (90–110 km/h) normal for the DL501/S tronic in a 2.0 TDI quattro? Could this be mostly gearbox calibration/normal behaviour, or should I suspect adaptation, engine/gearbox mounts, drivetrain play, mechatronics, clutch adaptation, etc.? Could DPF condition/regeneration/ECU adaptation have any effect on this kind of light-load gear hunting, or is that unlikely? Would a proper S tronic adaptation/basic setting with VCDS or ODIS be worth doing, or is it better not to touch it if there are no faults? For those with similar cars, how does your gearbox behave around 60–65 mph (around 100 km/h) in D mode on slight inclines or with small throttle changes? Is there anything specific I should check before worrying about the gearbox itself? I am not looking to immediately rebuild the gearbox or overreact, I just want to understand whether this is normal S tronic character or something that should be investigated further. Any experience with A4/A5/Q5 B8/B8.5 2.0 TDI or 3.0 TDI quattro S tronic cars would be appreciated. Thanks!