All Activity
- Past hour
-
Hi I’ve got the exact Same fault on my A4, did you find a fix?
-
Hindy joined the community -
I was hoping video would give an idea of what it was , you can really hear it at 31 seconds in .
-
I would apart from the fact that they are getting close to end of life thread getting low and would rather the deeper thread on the front.
-
SamB05 joined the community -
I had my rear right wheel bearing changed last month which was quite severe almost sounded like a helicopter noise mechanic changed if I remember correctly cost about £120 problem sorted instantly
- Today
-
You're welcome, doesn't sound like the battery is at fault. Could it be an issue with the instrument cluster?
-
This article might help: Either way check near the manifold, cat, or other places along the exhaust or even dpf.
-
You're welcome. If it is the ballast then this can be changed but might need to be coded in.
-
Good evening dear colleagues and Audi owners, on my Audi A6 c7 2014. 3.0 bitdi quattro the yellow engine appeared on the dashboard, and I put obd 11 to see what error I get and I discovered a P242B, I understood that it is an exhaust gas temperature sensor, and I would like if any colleague could tell me where it is located and a code on the part to change it, thank you!
-
GeorgeB2000 joined the community -
Repeating :-well worth putting the pair of Hankooks on the front.
-
You don’t need a tester to inspect the condition of the cables within the flexible harness section Kieran.
-
mate did a scan and this is what came up ....i did repair my glovebox the other day and turned the passenger airbag off and disconnected the wires .....maybe thats summat to do with the problem???? 1,Audi,,2008,WAUZZZ8P28A173279,979860329838,1749829495,-1.pdf 2.pdf
-
Thanks Steve
-
I haven't got a tester at the moment unfortunately
-
Someday1 joined the community -
Hankook the other wheels , like I said I had a blowout and that tyre was the only one available at that time .
-
How to use Plug & Charge. -
How to use the Audi e-tron route planner with MMI. -
How to optimise charging capacity in the winter. -
How to utilise MMI for vehicle charging. -
How to plan your route with the myAudi App. -
How to charge your vehicle with myAudi App. -
How to set up your myAudi App and connect to your car. -
RoadX - sounds like Chinese best, and personally I wouldn’t opt for that and another unknown brand on the front axle. What brands and remaining tread do you have on the back ones?
-
cat boy joined the community -
Checked my advice then Keiran?
-
Leli joined the community -
Avanti66 joined the community -
You'll need a diagnostic check to see if any fault codes flag up. Could be an issue with the ballast
-
The hazards switch doesn't seem to be playing up at all i had someone come out and test with a multi meter they proved that the light unit and bulb holder is fine it just isnt getting the power to it he suggested it might be the power moduler but I cant find which one it is
-
Topics
-
