All Activity
- Past hour
-
faulkner1213 joined the community
-
OK Paul, You have had suggestions of what to do to progress this issue and we given you contacts to approach who might help you. I appears, in your opinion, that whatever help you have been given has been inadequate - possibly since you are not hearing proof positive that the new part is faulty. It would also appear that you are getting towards loggerheads with Lookers. So perhaps it is best that we too state that ‘we are out’ as well. You can help some, but it gets difficult to help those who just want confirmation that they are correct . They may be, but not always. Good luck in sorting it out to your satisfaction.
- Today
-
Alright thanks everyone. its a two year warranty. i guess i was hoping for technical advice rather than life advice. I'm sure you all mean well. im out
-
I assume the large wheels will have very low profile tyres, an arrangement that is known to produce a much harsher ride than normal, so it's reasonable to believe that is what has knocked out springs and bearings. Not sure about the drive shafts.
-
pktshu started following Manual gearbox oil
-
Hello all Sorry to ask but my head is spinning with so many different answers regarding which GB oil is the correct 😓 I have a 2017 A6 C7 2.0 Tdi Ultra, DDDA engine with a manual RYS gearbox...I need some help finding the right spec oil please 🙏🙏🙏🙏 Thank you all and sorry for the trouble. Regards
-
Audi A4 2015 TFSI/Auto cold start stalling issue
cliffcoggin replied to Davej146's topic in Audi A4 (B8) Forum
Did you have the new battery coded to the car? It won't work properly until you do.- 2 replies
-
- cold start
- stall
-
(and 2 more)
Tagged with:
-
Wilburys
-
Macky67 started following A6 Avant Ultra TDi wheel size change.
-
I bought the above in Feb this year,not my first Audi,with standard 17" alloys. One week later I put on a set of genuine 20" Rotors with correct tyre size ,profile etc. The next day a front spring snapped while parked up. I replaced both springs, since then I've had to replace both front bearings and driveshafts. All inside 2k miles. The car had 90k on it. So? Was this just mileage sensitive wear or have these wheels been the cause? Wheel alignment was done when fitting the bigger wheels. Just unlucky?
-
-
-
-
2.0 TDI metallic ticking noise from bottom of engine
Steve Q replied to jc07030's topic in Audi A3 (8V) Forum
I'd get this into a garage asap. Let's hope it's a chain and not the crankshaft etc. -
Audi A4 2015 TFSI/Auto cold start stalling issue
Steve Q replied to Davej146's topic in Audi A4 (B8) Forum
This link might help: https://www.audiworld.com/forums/a4-b8-platform-discussion-128/random-dying-cold-start-3068600/- 2 replies
-
- 1
-
-
- cold start
- stall
-
(and 2 more)
Tagged with:
-
This link might help with the sloshing https://www.audizine.com/forum/showthread.php/624964-Water-sound-behind-dash
-
This link and video might help: https://www.audi-sport.net/xf/threads/159097/
-
New S5 owner joined the community
-
I'd recommend a diagnostic check to see if any fault codes flag up or get an auto electrician to take a look.
-
Traveling
-
New member Doncaster area looking for repairs/ service
Steve Q replied to AlbertSteptoe's topic in Audi A2 Club
Welcome to the forum you'll find the members on here are a friendly and helpful bunch 🙂 -
Davej146 started following Audi A4 2015 TFSI/Auto cold start stalling issue
-
Hi. I seem to have an issue when starting the car from cold. The car starts fine from cold but after around 30-60 secs, it starts vibrating/shuddering and the engine stalls. A message comes up stating: start/stop system fault. Function unavailable. No other errors or fault codes come up. I wait about 1 minute and start up the car again. Sometimes it starts fine from the second attempt and this time no vibrating/shuddering or stalling. Sometimes it takes 2 or 3 further attempts to start the car eventually without stalling but then it runs fine. The strange thing is that it only does this at cold start. The car runs fine for the rest of the day with several engine starts without stalling or vibrating. Also the start/stop system works fine for the rest of the day. This has happened at the current time which is during summer and not at cold weather conditions. I have bought a new battery as the battery was a bit old but the problem persisted even after installing a new battery. Any help in identifying the cause of this issue would be appreciated.
- 2 replies
-
- cold start
- stall
-
(and 2 more)
Tagged with:
-
Still knocking, has been to three garages now, no one seems able to diagnose the issue just want to start swapping out parts which I'm not keen to do as it gets pricey, battery was diagnosed as faulty (replaced and wasn't the original), TPMS sensors seem to have a mind of their own.....TBH is feeling a bit flaky as a vehicle, had multiple BMWs before this and never suffered this many faults this side of 100K
-
Simon I joined the community
-
Macky67 joined the community
-
Supaduper joined the community
-
stuie23 started following Egr location removal and cleaning
-
Hi I've a 2010 audi a3 8p 2.0 tdi I'm struggling to find the location of egr also instructions how to take out and clean wen put back on does it affect codes or the computer etc too many thanks stu
-
stuie23 joined the community
-
New member Doncaster area looking for repairs/ service
AlbertSteptoe replied to AlbertSteptoe's topic in Audi A2 Club
Hi Cliff , yes lots of miles 170,000 -I'll look for VAG specialist great idea thank you . I'm not a mechanic in any form - and not much money -
New member Doncaster area looking for repairs/ service
cliffcoggin replied to AlbertSteptoe's topic in Audi A2 Club
You have not mentioned the mileage Steve, but at 22 years old your car must have done a circuit or two around the Earth. Most of us recommend independant VAG specialists rather than Audi main dealers. An internet search for "VAG specialist" should reveal several in your area. -
jc07030 started following 2.0 TDI metallic ticking noise from bottom of engine
-
Hi, Anyone familiar with this metallic ticking noise? Sounds like loose chain, but it is 2.0 TDI on Audi A3 8V. Could it be sign of oil pump going bad? VID_20250710_140426107~3.mp4 VID_20250711_101802402~2.mp4
-
Lajar joined the community
-
AlbertSteptoe started following New member Doncaster area looking for repairs/ service
-
Hello I'm a new member with an Audi A2 2003 (I've had it over ten years car not knocking)with a knocking noise, sounds from engine /suspension area - I'm definitely not a mechanical person I just love quirky motors . looking for local Audi member rather than main dealers

-
Topics