cliffcoggin

In summary: cold starting is fine, hot starting is erratic, and the engine runs well once started. If that is correct I suggest there is an electrical or mechanical problem, though that doesn't narrow the field down much. ECM, mass flow sensor, crankshaft sensor, exhaust sensor, fuel injector, and many more could be at fault. I doubt we shall arrive at a firm diagnosis from discussion on this forum, and guessing at answers will be expensive for you, so I suggest you get it tested at an Audi dealer or independant Audi specialist. Do not use on an OBD reader from Ebay or the like, they are unreliable.

Petrol or diesel?

A simple voltage test will not always reveal internal battery faults, nor will such faults necessarily interfere when used in another vehicle. If the problem occurs again I recommend you fit a new battery before spending a lot of time and money on sensors.

Was that a new battery you fitted or a secondhand battery? Dodgy batteries are known to disturb the cars electronics leading to apparently unrelated warnings, false error messages, and symptoms such as limp mode.

Good. How much did it cost to have repaired if I may ask?

Tested by whom, and in what way? That the fuses are OK is irrelevent; it is the circuit board or its components that get damaged as I understand the matter, though I must add that is the full extent of my understanding.

It is not an unusual fault on A3s. They can be repaired by specialist companies for about £200, much cheaper than a new one from Audi. Search on line for such companies.

No it's not normal for a bearing to fail after 18000 miles, which is why I think the noise is caused by something else. A worn bearing would in any case make a very different noise. You can check the bearing by jacking the wheel off the ground, then rotating it. A low pitched rumble would indicate wear; a scraping or rubbing sound is something else. Grab the wheel top and bottom and try to rock it. There should be no movement if the bearing is sound. (Doing the same thing holding the wheel at left and right can be deceptive because of movement in the steering joints.) While the wheel is in the air look for damaged tyre tread, rubbing brake pad, a warped disc. While at 40 mph is there any vibration at the steering wheel? Does the car steer true or does it try to wander at that speed? Let us know the outcome of these tests and we can advise further.

Phew. It's like pulling teeth today.

That's a good result Gareth. I see the replacements are less than £16 on Ebay so quite a saving on Audi.

You mean the car has been modified? Please give some more details about the "hot fix".

Gareth. A Google search came up with https://www.a1-diagnostics.com/audi-specialist-cardiff/ You can bet they are not cheap, but a phone call might get you a diagnostic cost even if you don't get them to do the repair.

That sounds like a poor ground (earth) at the aerial.

Ah, that could be a problem. I no longer have my A3 and can't recall whether it had a key lock. Sorry, I am stumped.

The difference is impressive.

As Steve said, what about the boot? That would at least prove whether the key is at fault.

I don't know how possible it is. Electronics is not my forte. Legally you may be on thin ice as there are regulations on how loud an alarm can be, and how long it can sound for.

Tungsten and halogen bulbs deteriorate over time, getting gradually dimmer. If yours are original it would be worth renewing them. Conversion to LED is apparently not straightforward from what I have read here.

Raphael. Have you tried the key in every lock? I can believe the linkage breaking in one door, but not all of them.

Raphael. It's hard to believe the key will not unlock the driver's door, even though the car battery may be flat, without a breakage of the mechanical linkage inside the door. Are you sure it is not unlocking? Don't be deceived by the lack of noise usually made by the solenoids. The key should still unlock only the door it is used in.

Hello Honey. You could try car breakers, many are online nowadays, but I think it's unlikely you will find one outside an Audi dealership.

Sorry Loquex. As usual with recordings made on a phone there is too much extraneous noise to hear whatever you are referring to.

Hello Gareth. I've not had that problem so no direct experience. Assuming the sensors are clean, I suggest looking for water ingress or a damaged wire. I daresay you have probably already thought of that so apologies if I am teaching grandma how to suck eggs.

Most pads have an adhesive that is softened by heat, so try a hair dryer, but not a paint stripping heat gun which is too hot.

That's unfortunate.