Latest Posts
Showing topics posted in for the last 365 days.
- Past hour
-
Audi A4 B8 2012 Bluetooth Settings in Green Menu
ryan-m replied to ryan-m's topic in Audi A4 (B8) Forum
-
Hiya folks…. Apologies to reply to, and drag back up to the top an old thread. I’ve not seen any other threads like this (but it has been a long week!!) is there a way around this? Code it out or similar? Every trip for almost two years now I have to change from efficiency drive mode to something else and back again to fully get efficiency mode gearbox (with intelligent free wheel etc…. I’ve poked around in VCDS but I’m very new to it. I’ve done basic settings and addressing of some heater flaps and I felt very smug at achieving that much 😂
- Today
-
Just purchased my 2021 E-Tron 50 and my AC has the same behaviour. It comes on initially and then stops working after a minute or so. I have a 60 day Arnold Clark warranty and i actually purchased an Audi extended warranty that starts in June too. Seems to be a pretty common fault unfortunately and bad timing with the current weather :-(
-
Driving the car back on a 12 mile round trip and the ‘checking engine light” came on. The car is a 3 yo A6 C8 40 TDi with 15,000 miles on the clock.Any ideas on what to check first? Is this a sensor fault or soot build-up? Thanks in advance for any gen
-
So... Camshaft magnets done, car insured again, idles smooth and knocking noise gone quiet Gone to take car into a friend's bodyshop (5 mile drive) Knocking nose starts again just down the road from bodyshop and starts running rough, sounds almost like metal on metal, plugged diagnostic in and cylinder 4 misfire. Compression test shows (from 1 to 4) 175 - 175 - 175 - 150. Looks like im going to need a new engine at this rate 🤔 🙃
-
as i posted ...above
-
Hi guys, air blower not working on my 2010 SLine TDE. The lights come on, but no and the dial goes up and down when adjusting it, but blower not kicking in, took blower out and it spins freely, guy at scrap yard checked it and said blower motor is fine, ordered a new resister and fitted it, but still the same, ( I suspect the new resister is faulty). How can i test the resister to see if its working or not? And if resister is ok what else could be the problem?? I have check fuse and thats ok. Thanks
-
Has it got an SD card slot. If so I can recommend https://www.navboost.co.uk/. I upgraded my wife's 2017 A3 to include apple airplay using the software this company provided. Even though I had a few issues (which in the end turned out to be my fault and using the wrong cable) the customer service was astonishingly good.
-
MMI part number - 2013 A6 Allroad
robboquattro replied to robboquattro's topic in Audi A6 (C7) Forum
Thanks Steve, that's a logical starting point. I'll see what I can find through them -
No reason but I'll defo try PIM next time I need something.
-
A faulty wheel speed sensor
-
Yeah was gonna do this. Don't fancy chasing wire all all around the car. Done that years ago in an old E30, that was ok because they didn't have the speakers in the doors just in the front kick panels and rear shelves. Plus not replacing the whole system like I read some have done, just the speakers that have blown. I actually quite like the sound in our A4.
-
Hi all, newbie here, I have a 2014 Audi Q7 which is now due service as light is on. I am more than capable of doing the service work myself and would rather do it myself after bad experiances with a few garages not doing all the work and making mistakes. Only issue is resetting service light, I know you can reset oil change light yourself easily but obviously resetting service is a different game as you need correct VAG equipment to reset. Does anyone know of a hand held scanner which will definitely reset the service light as a few claim to but im not sure. There are a few scanners around the £150 mark which i dont mind spending but any advice would be amazing, many thanks.
-
Well, still no idea what that telephone fuse is doing on the MMI loop, but to solve the issue, I wired the fuse to power only on ignition not constant live. Car still struggled to start in the morning, but it did on first try, it's never done that before. It was constantly drawing 7 amps, got it down to 0.9. I think I need a new battery as that's been up and down for so long. Let's hope this fixes it for now and I can remove the second battery. I fitted the missing mmi mechanism, somehow it doesn't fully sit in the dash, but pops up fine and the switches on the mechanism are now pressed. That's a job for another day..
-
Hello, I got the dreaded shift to P before leaving blah blah blah warning, took the gear selector apart, found the colour of the bypass switch I would need, ordered, tried to fit, does not fit. tried the black one, also does not fit. I do not want to change the whole gear selector, one price, two the car is not even 5 with less than 40k miles, three it’s a hassle to change and I could be asking for more issues. Does anyone know how to fix this that doesn’t require a whole new selector or parts 500-713-128-A & 3Q0-713-128?
-
Good Morning. I was wondering if anyone has had experience of the gear stick becoming "floppy", ie. not returning to its central position when not in gear. I could get the gears okay, but I had to be very careful so as not to select the wrong gear. I have taken all of the gear stick components out, and there are now just two rods in view that connect to the gear box. My question is :- is the centralisation of the gear stick controlled by the round gear box rod, or within the ball type assembly at the base of the gear lever? Any help would be greatly appreciated.
-
Thank you for joining and advertising Samcurman. Having said that, I really don’t see this being particularly inviting as listed. Could you please amend your Profile to include your location - big place is your ‘united kingdom’! This would be considered important detail since it’s likely this would be sold via. ‘Collection only’. Other vital details not included:- Price. ( ‘Offers’ not acceptable). Condition. Please come back to us on all points raised. Regards, Gareth.
-
Lost Communication with tcm after jump start
dannyanny246 replied to dannyanny246's topic in Audi A3 (8P) Forum
Just pulled the cover off the module, everything looks in decent order, no fried bits. Gave everything a thorough blast with contact cleaner. Put it back together and plugged it back in. And sadly nothing. -
Please keep us posted on how you get on. Also the VW T-Roc or Seat Ateca one might fit as they're sisters to the q2.
-
Glad we've helped 🙂
-
Looks great 👍 🙂
- 1 reply
-
- 1
-
- Yesterday
-
Any updates or replies to questions Leo?
-
Most certainly does 😉
