Redred Posted May 15 Posted May 15 Hi all, the clutch on my 1.4 A4 seems really high. It doesn’t seem to be slipping, but if I do a spirited launch from standstill then there’s a squealing metallic sound from the engine bay just while the clutch is slipping until fully engaged. Doesn’t do it at low power takeoffs. Considering the mental cost of doing the clutch on these cars I’m considering whether I should gamble that it could go on like this for a long time or move it on before it fails. Could any fellow owners let me know if a high clutch biting point is normal on the 1.4?
cliffcoggin Posted May 18 Posted May 18 On 5/15/2025 at 7:47 AM, Redred said: Could any fellow owners let me know if a high clutch biting point is normal on the 1.4? It's not normal on any car. Your clutch is defective.
Redred Posted May 26 Author Posted May 26 Hi Cliffcoggin, I was hoping for other replies from A4 owners to say where their clutch biting point is in comparison. I’ve done some research regarding the squealing sound, and it seems like that could be the release bearing, or (worse) something to do with the flywheel surface. I’ve also tried to ascertain whether it is actually slipping yet and it isn’t, as far as I can tell from the normal tests. If it was cheaper then I’d give serious thought to changing it out anyway, but apparently this clutch pack isn’t available from 3rd parties yet so the Audi price is something like £2K5 just for the part. I need to verify that’s still the case.
cliffcoggin Posted May 26 Posted May 26 Yes the squeal is most likely to be the release bearing. Adding that to the high bite point confirms that the clutch is defective and needs to be renewed. Others here may be able to recommend a source for a new clutch.
Sid2020 Posted May 28 Posted May 28 The longer you drive with a defective clutch you run the risk of damaging your DMF which would cost you alot to replace, I would change it sooner rather then later. My biting point with old clutch and new clutch is smack in the middle. Sacs clutch’s like what will be fitted to b9’s shouldn’t experience bite point travel, they usually just start slipping once all travel is used
alpha omega Posted May 28 Posted May 28 (edited) i bought an audi a 4 b8 with bills and with one bill it said clutch high.it showed no signs of slipping then 3.5 years later it suddenly started to go then went completely while on a busy by pass.all changed including fly wheel £1500 garage in north yorkshire Edited May 28 by alpha omega
cliffcoggin Posted Tuesday at 04:09 PM Posted Tuesday at 04:09 PM Any comment on the last three replies Dm? I know you have seen them. 1
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now