morning all, had 10 faults this morning after car wrapped and all of them cleared apart from below

 

tried 4 times. 

do i need to clear, power off and try again?

 

 

Do I recall the door handles were taken off during the wrap?

By the wrappers?

handles as wrapped black, doors etc to wrap

all the codes cleared apart from the photo after a few goes.

was it as engine was running? will it clear after a drive?

Edited September 3, 2025Sep 3 by thatukguy_james

Sorry James, not understanding your reply in regard to:- 

Were the handle assemblies removed from the car before the car was wrapped? 

all codes cleaned this morning ok 

 

doors etc and handles were removed and bumpers and i know he drove the car a few units down as a small oil leak.

so this must of made the sticky frault?

Edited September 4, 2025Sep 4 by thatukguy_james

So the handles were removed then, and that operation is likely to be the culprit with your current issue.