Skip to content
View in the app

A better way to browse. Learn more.

Audi Owners Club (UK)

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Welcome to the Audi Owners' Club - An Independent community!

Membership is completely free, and our community is built by enthusiasts, for enthusiasts. We’re a proudly independentnon-official club, so all the help and opinions you’ll find here come directly from members with real experience of Audi ownership.

Join the club now!

 

Help to diagnose Audi A4 B8 please

Featured Replies

Hi,
I have an Audi A4, B8, Multitronic, 2.0 TDI and it has developed some symptoms:

- increased fuel consumption (poor mpg)

- slight engine shaking but become worse when I switch off the engine (the whole car shakes a lot more on the moment between pressing the key to switch off until the engine dies completely)

- a while back I've noticed that for the first time on the day the car won't start at first attempt but at the second. Now, it will not start after 3-5 attempts. I press the key, the engine cranks but just when it's about to fire, it dies like something it's not there, like the fuel just ran out. When it won't start, the cranking time is the same as when it does start, the car does not crank longer. It will happen only when I use the car for the first time on that day after which the car will start at first attempt perfectly fine every time until next day. Battery is new/good and it's summer at the moment.

There are no fault codes on VCDS. However, after my research, I think there is an issue with either MAF sensor or EGR (or both).

I have attached 2 screenshots from VCDS with engine at idle, do these values look abnormal?

Thank you,
George

Screen Shot 2023-08-17 at 20.23.08.jpg

Screen Shot 2023-08-17 at 20.22.55.jpg

  • Author

I've scanned it multiple times with VCDS and there are no fault codes. Also, I've been to various garages, they've also scanned it and found nothing.

I did think of cam sensor but I cannot locate it. Engine J623-CAGA. Any directions or pictures please?

This morning I have disconnected the MAF before starting the engine but it made no difference, still didn't start at first attempt. I would imagine is not the MAF in this case? Also, looking at the above VCDS pictures, Air mass: specified value and Actual air mass are similar so I assume that's good, right?

Cheers!

Edited by george_nn

In the old days if maf was at fault more often than not the engine would run better so I'd cancel.tgst out. 

Not sure where the can sensor is located. 

Could it also be a lambda sensor? 

I'd also advise Changing the spark plugs and ht leads. 

  • Author

When the MAF sensor is disconnected, the car runs about the same, I don't notice any difference.

The car has new glow plugs.

Create an account or sign in to comment





Background Picker
Customize Layout

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.