Headlight range control system fault

[Rahim k]

Does anyone know what this fault is?

thanks

[Steve Q]

You'll need a diagnostic check to see if any fault codes flag up. Could be an issue with the ballast 

[Rahim k]

Thanks Steve

[Steve Q]

You're welcome. If it is the ballast then this can be changed but might need to be coded in. 

[Rybrook]

Range control is the level sensors on the front and rear lower control arms, easily damaged when working on suspension, I snapped mine so 3d printed a new arm from an A6 all-road air suspension sensor.

They can also go bad when the abs sensors break.

[Rahim k]

I got my level sensors changed but I think it’s more to do with coding. If coding don't work then its definitely the ballast . Im taking it to the garage to get it checked.

[Steve Q]

1 minute ago, Rahim k said:

I got my level sensors changed but I think it’s more to do with coding. If coding don't work then its definitely the ballast . Im taking it to the garage to get it checked.

Please keep us posted on how you get on 

[Rahim k]

hi guys,

I just went to the garage and they gave me this reading from diagnostics.

C108515 55 - HRA: Left headlamp beam adjusting motor Open circuit/ short circuit to B+

any ideas on how to get this repaired?

The garage told me possible the whole headlight need to be changed.

thankS

 

 

 

[Rybrook]

You may need check the wiring and the connectors for water ingress, not easy because it's tight. 

You could possibly get a picture of the inside by removing the road wheel, arch liner access and disconnecting the ignitor.

Or remove the unit from the car to check it.

I put it on water that's got in somehow and is bridging the contacts.