CoventryAudi

You'll get about 42mpg Its the Ea211 engine The Ea211 evo 1.5 has faults such as stalling and kangarooing

Silica bag has split

Bumper insert. Pop it out and vinyl wrap in gloss black

Tiny damage, SMART repair - £120

Check the roof antenna seal Check the tailgate loom covers on both sides Fold back seats down and check bottom boot lip seal from inside car with tailgate closed - if see daylight it needs bending up - easy Check tailgate bottom drain holes are clear Check Wiper motor rubber seal/bung Seen others that have said the spoiler brake light

6Q0807180 is the part number they are £3.12

I replaced the parts for the cover they are sold on ebay

I sold a motor 8 months ago. Some ebay scammer wanted to 'return it' as said wasnt the right part....( he would have sent me back his faulty one and claim it was mine)

Save your cash and buy a RWD car. I own a A3 8v and doesn'tgive much joy driving. RWD merc jag or BMW. Previous car was a W204 owned for a long time. It was a great car to drive. i regret selling but did due to impending CAZ's

Silica bag had split! Remove it before this happens!!!!!

Ea211 1.0? Should be adequate Ea211 1.5 evo has many complaints about stalling as opposed the ea211 1.4 it replaced apart from in the hybrids that has seen decent miles covered

Theres a genuine after market rear sensor kit ive seen available on ebay for about £92. Holes to be drilled - crosshairs already marked on inside of rear bumper. Where are you located? Not too difficult to remove the rear bumper you will need a 10 mm socket (deep socket made by laser tools) Torx bits for the screws in the arches Dont forget to remove the clusters first and a black plastic locking wedge on either side

Bumpers, side skirts and wheels to change also to make a look a like. Parts were cheap 12 months ago but now silly money

8v4 827 933 C for 5 door 8v3 827 933 c for three door Easy to swap Remove tailgate trim Access the 10mm nuts x 4 and remove them Lever off old spoiler held on with 4 plastic clips and unclip brake light cable connection

Comes up as ABS pump?

Good afternoon I want to replace the rear apron sheet metal on the rear of a Audi A3 8v..... Does anyone know how it is affixed without me stripping it down and having a poke around? Ive the part already from Audi and theres nothing on any parts diagram websites of how its secured on. Audi suggested it may be riveted but i assume spot weld. Any advice be appreciated!