Latest Posts

Just a small update, while waiting for the ecu to arrive, nearly all wiring that is not required has been removed. The ecu will go behind the glovebox as thats where the engine wiring will come through. The column switches will probably be removed, as the new switches will be on the new steering wheel.

Hi Kyle, I just filled it up to the max line, started the car and let it run for few minutes, then topped it up a bit more. Took it for a 5 mile drive and checked the level after, let it cool down and topped it up again. (keep monitoring for a few days after) Hope this helps

Hi mate some good info on there, thanks for the help Im prepared for the maintenance costs. on the diesel side with the DPF filter etc. do you have any advice on mileage should i be doing to avoid carbon build up. I wont be using the vehicle daily but im prepared to do a long trip at least once a month to prevent particle issues. What is a short run by a diesel engine standard? once again thanks Owen

Hi fit a new DAB antenna, loads on line that are better than the oe but first check the antenna on the roof as they often suffer with corrosion and don't work properly, my car was the same and I replaced all of the usual suspects with only a little improvement so I had convinced myself it must be my area, but the Passat I have's a similar set up but the only time it cuts out is when I get an electric bus along side me. Steve.

Oh the joys of a failing battery … even that isn’t simple anymore 🤔😂

Sorry, not sure. I do not think the engine shape has changed so the earlier top cover may fit. If you know some one with the earlier model it is worth trying to see.

ooof! £200 is wild for what it actually is. I did purchase the part linked and have been running it for a few months now with no issue. It just stings when you see the alternate part for the later versions of this engine going for £25 - £30 for well known aftermarket manufacturers. Either way I hope it helps with OP!

Hi Cliff P2002 is like the tax man it won't go away unless you pay for it, just discovered Jimmy O Riley's latest Ultra posting whereby the code is present and can't be cleared due to some Clown trying to delete Low/High pressure DPF software so even after cleaning the code won't go and the DPF won't regenerate, he apparently now has the facility to re flash the ECU with the standard software and that seems to work but only after cleaning, he also states that the problem will always return because of the design, believe me it always came back on my car and that had practically every emissions part renewed at some point, they are just money pits. Steve.

Hi, checked Ebay and FB marketplace. I cannot see anything in reasonable condition/price ratio. Posted a request to Parts Gateway, still no response. Any other parts breaker sites you can recommend?

Thank you..

Full piece for a rs4 b8 front passenger with shocker spring knuckle connector and drc pipe with the shocker just the pipe is £300 I’m looking for £200 for the full thing bargain for someone

Got a 8p gearbox 6 speed KDT Bought it for a s3 for replacement but sold the car instead so didn’t put it on Travelled 3 and half hour to get this from where I am Come out of a 90k s3 comes with all the bits attached to it so it’s ready to go in only thing guy told me needs changing is the oil plug which is £10-20 no biggie KDT CODE comes with transfer box I paid £250 I would like £200 back it’s not missing anything clutch and flywheel and your ready to go I do also have some clutch is unbranded but it is brand new can chuck it in £50 extra it is definitely for s3 bhz/cdl Collection dewsbury Thankyou

I'd also get your timing chain checked, sounds like it could be stretched especially at that mileage. The sooner you check it the better as leaving it could be terminal.

Hey all, Newbie here and just looking for advice. I have an early 2007 A3 8P I'm slowly working on getting in good running order as well as aiming for an OEM+ build to learn more about cars. This weekend I attempted to install a turbo muffler delete, however once I get in there I realised the bolt patterns were completely off. Does anyone here know if there is a turbo muffler delete that would fit this pattern? Everything I search for is coming up with the symmetric bolt pattern, not the asymmetric. Photo for context, left is OEM and right is the incorrect delete I purchased. Any help would be greatly appreciated!!

Hi All 2018 S3 Sportback. A recent service has flagged a fault with exhaust flap 1 actuator as open circuit. Whilst it does not affect the running of the car it would be good to rectify. I have done some preliminary checks. Flap actuator 2 is fine and the fault does not move when I interchange the actuators. Wiring at the connector is OK. From the wiring diagram, the circuit splits to feed both actuators somewhere in the harness at point B350, “Positive connection 1 (87a) in wiring harness”. Without me having to start dismantling the trim, would anyone have an idea of where this point would be in the car? Thanks in advance.

As said a year ago Colin. If they are original fitment then just look where I advised you to last year. If they weren’t an available and acceptable fitment - good luck with your insurance. Regards, Gareth.

I have a 2018 S3 and 2019 A3 1.5 TFSI. I do all my own servicing and change the oil at 8000 miles. The A3 has done 91000 and the only thing we have done is change the DSG clutch pack. The mechanic showed us the one that came out and reckoned it had a lot more life in it but we had a fault message and juddering in the low gears. It has been a great reliable car as has the S3. Having done some research these engines can go for 150K plus. I run my cars into the ground so hope this is the case. FYI I saw a 2018 Toyota Prius hybrid with 330000 on the clock. This chap had the car from new and changed the oil every 8000 miles. Not sure on the finance bit as I buy the cars outright but I feel confident they have plent of miles in them.

For sale Rs5 private plate for sale offers over £500 RS5 4ME X

My thoughts as well Thank you.

Has anyone on here used ecu testing for a mechatronic repair? I need to send my mechatronic off to be repaired I’ve seen mixed reviews

Interesting that Lenksäulensteuergerät translates as steering column control unit.

I’d probably get the matter resolved first and then insist on a meeting with the dealer principal.

If you’ve had S Tronic gearbox service (every 38k miles), and you have VCDS, then I would do gearbox adaption calibration in basic settings. Few videos as mentioned. Try than and see if any improvement.

Thanks Cliff I will have a look in yellow pages 👀

As a first step get the battery tested on deep discharge testing equipment. A dying battery could be your problem.