Latest Posts

Your Town/Country location Lukas - really??

I have not idea as i bought the car like that from previous owner he told me that the dpf has been removed i was driving it for like 4 months got it serviced and the engine light lit up got it changed and it lit up again with the same issue soo i dont know it could be pressure sensor

I've got this error code popping up once in a while (probably 1-2 years now if not more) and never on cold engine, only when fully warms up + some driving on top of it. Can also notice a drop in RPM. Jumping from gear to neutral right before coming to a stop is usually when it feels like it's getting in the zone of stalling 500-600RPM it seems, but it never does, just jerks a bit, and RPM goes up again. But if I give it gas it will likely drop afterwards again when in neutral. Enabling A/C does help with RPM, it becomes more stable in situations like this. Anyone dealt with this issue before ? Also idk if related, but gas station pump clicks and have to keep nozzle halfway in to fill it up. My guess would be to look at EVAP system, but would it be even related to p1031 ? Engine: 2L FSI 110kw petrol.

Evening everyone. Just purchased a 2015 Audi S7 V8 450bhp petrol with 96000 miles, lovely car but has just thrown up the error on my ODB2 o2 sensor signal stuck lean; bank 1 sensor 2. Is this an easy fix to do at home, or a garage job? If it can be done at home where can i find it? Thank you.

Does it really need to be spelled out?

Often get multiple faults after disconnecting the battery. Need to leave it disconnected for about 30 mins. Usually clears after driving a couple of miles. If the airbag light stays on a useful fault code reader is OBDeleven that also resets fault codes. Basic version is about £50 and pro version about £80. Since dealers charge about £100 to run a diagnostic they are worth considering.

Think i have found the correct locations. The picture listed in the haynes workshop manual page 1A.10 calls this the filler but it looks to be the drain plug. The filler looks to be located higher up at the back of the gear box. The picture with the drive shaft shows the drain plug 17mm hex in the lower section. Other picture shows the filler plug just sticking out at the rear of the gear box. Will give this a go next weekend if the weather stays dry.

Update - received my obdeleven today and plugged it in. 3 persistent faults. MAF - understandable as unplugged Fault code 01314 Fault code 01592 Anyone think that either of these could contribute? Could 01314 be due to maf being unplugged?

Good. Your mechanic should have warned you of the potential for failure. Perhaps consider going elsewhere next time.

This might help but check the engine code https://r-techperformance.co.uk/axx-bwa-tfsi-k04-turbo-conversion/ Obviously it won't make the power on this website unless you add a whole load of supporting hardware. If you don't change the fuel pump at least change the follower if not already. Same with the PCV will most probably fail with more boost, rocker gaskets often go also. My TT has the KO4 from the standard since it uses the CDL engine. I got compressor surge trying to get past 350BHP so I had to get a better turbo and ditch the stock KO4

Maybe, but lack of coding can lead to the new battery being damaged by the charging circuits so I still suggest you get it tested.

I think this stage im just paranoid about my A6 , I've waited for years to get one as I could never afford one before in my life and I have now finally got the one I wanted " my dream machine " ( a 10 year old a6 I suppose some would say it's not much of a dream ) , but not that I have it im listening out for every knock and click and i find myself actually to nervous to enjoy it , with the fear of a major bill . And the thought of major gearbox damage has me actually sick to my stomach. I think it's time I just drive it and enjoy it , because it is a joy to drive . Thanks

That takes me back 50 years. I must have been mad, but I got away with it.

It’s asking me to press the clutch to start and when I do it goes off 🙂 don’t know if that helps

Thank you very much.

Fantastic work, hope you can get it back this week and enjoy it 🙂

As Dave has said it's often a loose wire under the passenger seat.

Welcome Kenny, but please give us some more information for members to go with. Could you please describe the problem you are having? Regards, Gareth.

Hi. If you have any issues with insurance at all for an imported vehicle then please feel free to drop me a line. Regards, Dan.

This is brilliant work

Hello Frank, Well worth searching EBay. Please let us know how you get on. Regards, Gareth.

I’m still learning “to drive” this forum and don’t know how to search it yet lol

Smiles your not wrong it already looks so much better happy days

Thanks Brian, Autodoc has had mention in relation to the supply of incorrect parts. I’ve never been affected by this, because I don’t buy from them, preferring not to pay highish postage charges compared with other suppliers. Regards, Gareth.

Absolutely Martin - it’s your car, and you are free to do with it what you will, and my feeling is that any advice given ( when asked for) which doesn’t concur with your views, will be ignored. I certainly won’t be chasing you again for a thread-closing update, since I feel the tread will remain as ‘unsolved’ anyway.