Latest Posts
Showing topics posted in for the last 365 days.
- Past hour
-
No they didn't. I would have taken that if I could. Tony
-
EBay, breaking Audi 80’s
- Today
-
Hi guys please forgive me if this has been asked many time I have tried looking if it has but still learning how to navigate the site. I am looking for a honey comb grille for my a4 b8 avant s line will this all I look at say not suitable for s line. Anyone purchased and fitted one? If so please guide me to where you obtained it many thanks in advance and apologies if asked before regards Tim
-
Yeah it’s all just nuts and bolts at the end of the day!! The actuator only seems to have a threaded nut to set it so I think if I could find the tolerance or measurement online it’s not too tricky. There were no issues with the oil feed and no leaks. Gaskets were all fine except for the one between the manifold and the EGR so I replaced that one. I’m using an Ancel VD700 to read codes etc but it’s not throwing out any codes. As a side note I’ve driven 300 miles today and it’s not happened so it’s one of those intermittent things. I’ll find it at some point I guess!!
-
Thank you I will take a little time to learn how to navigate the forum but hope to involve myself more in future
-
The first picture shows the drain plug, I left the hex to show where it's located in ref to the filler plug in the 2nd picture
-
Thank for the video, however, I am disabled and can't remove this myself. I had it costed at well over £500. So the buttons on a 22 year old car at less than £10 v £500 is a no brainer for me. I have seen pictures of vehicles other than Audi's with this fix, but can't seen to find out if it's possible to fit the screws into the roof shell e.g. if it's a cardboard composite or is it fiberglass.
-
Many thanks, I’ll give it a go 👍
-
Glad you're nearly sorted. Sorry the last bit isn't working.
-
Check the fuses!
-
Audi A6c8 rear spring lower mounting corrosion
spartacus 68 replied to Mickwillow's topic in Audi A6 (C8) Forum
Waxoil won't stop the corrosion. The alloy insert is there to strengthen the rubber suspension seat. It corrodes from the inside. Leave it and you risk the spring breaking. Easier to replace on a 2WD car. On quattro, you can remove lower shock mount. You need a piston jack to extend lower trailing arm down. Worst case scenario, loosen subframe bolt a few turns too. No need to undo the eccentric bolt either. -
Hello, I cant find them on there but thanks for the heads up, I made sure when i got these they were actually new stock not already a few years old like many have on offer. I Got these for my A8 so thought maybe a popular size to offer to members.
-
Hi all. Really sorry I forgot to post. This is how it went with Audi, Oldham. The technician told me that the diagnostic found no faults and that the issue was that I had deselected intelligent coasting in the MMI. He told me that he activated it again, drove up and down the motorway, and all is well. So…when I went to collect the car, and although I told him that the intelligent coasting mode had been switched off since new, he was adamant that this is what the issue was. Anyway, since being plugged in the diagnostic, and intelligent coasting off again, it’s back to normal !? I think a reset of the ‘brain’ of the car must have been done, but I wasn’t told that. in conclusion, when the electric charge is depleted, it shuts off the petrol engine into regen electric just as it should. The complete opposite to the issue I had, which was that the car never shut off the petrol engine, and instead decided to charge the battery, which resulted in sub 20 mpg for two weeks of driving. Again, sorry for this very late post and that I can’t be more helpful. Andrew
-
A ticking noise started on my car but it was hit or miss like i’d turn off my car go chill and then when i’d go back the ticking was gone then later on when i’d start up the car the ticking is back and just yesterday while i was driving it was ticking then the ticking went and a steering malfunction light came up so i went and pulled over started up the car again. And saw all driving assists were turned off. If you’ve experienced this please help me cause i’m struggling to diagnose the issue and people have been telling me it’s the steering rack but i’m not sure.
- Yesterday
-
Q7 4M Black alloy space saver 195x65x20
Magnet replied to Pappa583's topic in Audi Parts and Accessories For Sale & Wanted
Price Paul? Regards, Gareth. -
SD card will only work if sat nav is enabled on the MMI. If it's not enabled then its roughly a £500 job at the main dealer.
- 1 reply
-
- 1
-
-
New owner of Audi S1 year 2017, no working sat nav. Local service garage advised of sd card off amazon or ebay but don't seem to find one. Any suggestions please
-
Glad to hear you got it sorted Flatspell. To be fair, unless the garage specialise in Audi's, they may not know about this specific issue. They'll just replace the part that's likely to be the issue after a diagnosis scan.
-
Looking S6 C7 Brake Discs
cliffcoggin replied to Box Junction's topic in Audi Parts and Accessories For Sale & Wanted
If it is secondhand parts you want go to a car breaker. Why the clause about upgrading? -
Hi I have a brand new still in unopened box rs3 style front bumper to fit a3 8y all models apart from the rs3. £450 I bought this for a project car myself and my son are building (his 1st car). It’s a a3 8y s line 1L with light front end damage. We are building it as a Rs3 replica and have decided to use original rs3 parts.
-
Read a similar error, that was eventually traced to a vacuum leak off the EGR cooler. I think at the very least you are going to need VCDS and then measuring blocks which basically gives you live data. The fault code is one thing, but you need to understand why, and live data should help pinpoint. This was on 2010 model. https://www.audi-sport.net/xf/threads/378244/
- 1 reply
-
- 1
-
-
Go to a professional body shop. Had a similar issue with an old 2012 A4 Allroad. It’s classed as Platinum Grey 1RR, however will no doubt vary across models. When I spoke to Audi main dealer, it didn't even show up as a code. Phoned a few body shops and ones that are Audi and Porsche approved and they said it can’t be blended. Entire panel would need to be painted. As it’s matt/satin effect, it’s notoriously difficult to achieve consistent effect with rattle cans. Hope that helps.
-
ErWin, pay to view. You can download and print off pages you need. Given only 2018, then you’re going to need VCDS, plus if you buy additional parts, bear in mind they need to be new, otherwise you get into security component protection which only ODIS dealer level software can clear.
- Last week
-
Alternator failure related to mild hybrid system?
Voyt replied to PocketsAintEmptyCuh's topic in Audi A7 Club
Hi, so same happened to me… A7 50tdi 2019, all codes matched the document from previous posts, Audi UK pays for everything. Dealership said that the issue is known for about half a year and I should get back my car on Monday. Buckinghamshire -
Andy - Apple CarPlay is the app that enables your iPhone to work with the mmi. It's more than as Bluetooth connection it displays apps on the mmi screen and let's you use your iPhone apps on the mmi screen. If you plug in through your USB it should ask if you want to use carplay. I suspect that you also have wireless carplay capability - either way it makes your iPhone much more integrated with your car and you shouldn't need a USB stick.
